Alarm.Com ADC-V722W Installation Manual

Alarm.Com ADC-V722W Installation Manual

1080p indoor plus outdoor wi-fi video camera

Advertisement

1080p
INDOOR+
OUTDOOR
WI-FI VIDEO
CAMERA
INSTALLATION GUIDE
ADC-V722W

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ADC-V722W and is the answer not in the manual?

Questions and answers

Summary of Contents for Alarm.Com ADC-V722W

  • Page 1 1080p INDOOR+ OUTDOOR WI-FI VIDEO CAMERA INSTALLATION GUIDE ADC-V722W...
  • Page 3 • A computer, tablet, or smartphone with Wi-Fi is required if the router does not have the Wi-Fi Protected Setup (WPS) feature • Login and Password for the Alarm.com account to which you will add the camera Note: There are two options for connecting the ADC-V722W to the wireless network: Wi-Fi Protected Setup (WPS) Mode, and Access Point (AP) Mode.
  • Page 4 WPS Mode Add the Camera to an Alarm.com Account To ensure sufficient Wi-Fi signal, complete these steps with the camera near its final location but prior to mounting. Connect the camera’s AC power adapter and plug it into a non- switched outlet.
  • Page 5 On an Internet enabled device, connect to the wireless network “ALARM (XX:XX:XX)” where XX:XX:XX is the last six digits of the ADC-V722W’s MAC address, which is located on the back of the ADC-V722W. On the same device, open a web browser and enter “http://722winstall”...
  • Page 6 Local network and internet connection Flashing Green | Local network connection Local network connection only, no internet Solid Red | No network connection No local network or internet connection Flashing Red | System booting Camera is booting ADC-V722W Installation Guide...
  • Page 7 WARNING: This will restore factory-default settings to the camera. If already installed, the camera may need to be removed from the Alarm.com account and re-added after a factory reset. To perform a factory reset, push the WPS button and release when flashing Green and Red (about 15 seconds).
  • Page 8: Troubleshooting

    15 seconds), then release the button. The camera will reboot with factory defaults. If the camera was previously installed to an Alarm. com account, it will need to be deleted before it can be installed again. Questions? Visit: www.alarm.com/supportcenter ADC-V722W Installation Guide...
  • Page 9 Notes...
  • Page 10 Notes...
  • Page 12 © 2017 Alarm.com. All rights reserved. 8281 Greensboro Drive, Suite 100 Tysons, VA 22102 170512...

This manual is also suitable for:

Adc-v522ir

Table of Contents

Save PDF