PART D: Technical Alarms
Monitor Battery
Select "OK" and charge the monitor.
Sensor Battery
Replace sensor battery and select "OK" to continue.
Note: The sensor alerts its low battery status with one long
beep, then a short beep from the sensor.
Sensor Connection
Restart the Monitor. If this does not resolve the issue,
do one of the following:
•
Make sure sensor and Monitor are within 50 cm of
each other. Select "OK" to continue.
•
Change the sensor battery.
LifeWatch 24/7 Support
Call the LifeWatch Customer Care Center at
0850.433.25.88
for help with your MCT 3L system.
Illustrations included in this manual are general representations only and are not meant to comply with this specific regulatory requirement.
Please refer to the comprehensive Patient a User Guide for complete instructions and important warnings, cautions and for troubleshooting.
LifeWatch Services, Inc
444.25.88
Balgat Cankaya Anakara
©2016 LifeWatch Services, Inc. All rights reserved. The LifeWatch logo is a registered trademark of LifeWatch Services, Inc. LifeWatch reserves the right to change specifications at any time without notice.
SUP581 Rev A CR 16-458
info@lifewatch.com
www.lifewatch.com
INTERNATIONAL
LifeWatch Mobile Cardiac Telemetry 3 Lead (MCT 3L)
Quick Start Guide
Wear the sensor for the duration of prescribed time (except when
bathing or showering), even when you do not feel symptoms.
Sensor with Wires
A
Electrode Placement
B
Daily Use and Operation
Electrode Replacement and Return
C
Technical Alarms
D
End of Service Date:
!
Dial 112 for emergencies
Attention: The LifeWatch MCT 3L is a diagnostic tool only and is not part
of an emergency service.
Monitor
Electrodes
If not provided here, call
0850.433.25.88
LifeWatch at
Need help?
Do you have a question about the MCT 3L and is the answer not in the manual?
Questions and answers