Advertisement
Figure 11
Figure 12
Bexley Media Fireplace
Assembly Instructions
L
1
Attach wood holders (16) on the
sides of firebox (K). Insert 4pcs
screws (L) though pre-drilled holes
on wood holders (16) and tighten into
corresponding holes on the back of
side divided panels (6) and (7).
Use short screws to connect
brackets to the underside of the
top panel (1) as shown. Tighten
screw with Phillips screwdriver.
Drill 1/4 inch pilot holes in near
proximity of the brackets
attached to the top panel, then,
tap the plastic anchors into wall.
Use long screws to connect
1
brackets to plastic anchors on wall.
Tighten screws with phillips
screwdriver.
Move this item close to the
fastened wall brackets and tie in
both bracket with plastic straps
as shown in diagram.
Now your Bexley media
fireplace is ready to use.
Warning: Anti-tipping
hardware must be used for
this product to avoid tipping
and injury.
Advertisement
