Summary of Contents for Hypertec SBUPS600VA
-
Page 1: Power Supply
HYPERTEC UNINTERRUPTIBLE POWER SUPPLY USER’S MANUAL SBUPS600VA SBUPS1000VA SBUPS1500VA... -
Page 2: Table Of Contents
Contents General Safety Instructions Conditions of Use Electrical Safety Safe Operating Practices Battery Information Introduction Performance Installation Instructions Physical Appearance Front Panel Operational Indicators Operation Specification Maintenance Software Installation Load configure reference Troubleshooting... -
Page 3: General Safety Instructions
General safety instructions This manual contains important safety instructions that should be followed during the installation and maintenance of the UPS. Please read this manual thoroughly before attempting to install or operate this UPS. DO NOT under any circumstances attempt to remove the UPS cover. It may contain hazardous voltages internally that may cause electric shock. -
Page 4: Electrical Safety
Please verify that this model matches your AC mains / load voltage requirements. The Hypertec UPS must be earthed at all times during operation. This can be achieved by only connecting the input power chord to a mains supply socket outlet with an integral earth terminal. A means of disconnecting the mains supply should be within 2 meters of the UPS. -
Page 5: Safe Operating Practices
ON, even if the UPS is not plugged in to mains supply. The On/Off button on the UPS does not electrically isolate the internal parts. To isolate the UPS, switch the UPS OFF first, then unplug it from the mains. To reduce the risk of fire, use fuses with the correct rating when replacing fuses. - Page 6 aerosol cleaners. A dry cloth is recommended to remove dust from the surface of your UPS. Do not handle any metallic connector before the power has been disconnected. Turn off and unplug your UPS from the outlet and contact your nominated service agent if: The power cord or plug damaged.
-
Page 7: Battery Information
Remove watches, rings or other metal objects. Use tools with insulated handles. NOTE. The batteries used in your Hypertec UPS are maintenance free. This means that you DO NOT need to check the battery fluid levels. Trying to do so may cause injury to yourself, or may cause a fault with the battery / UPS. -
Page 8: Introduction
Introduction The Hypertec UPS can instantly switch your computer to emergency battery backup power and allows you to work through mains power outages without data loss or downtime. It continuously conditions the power coming into your computer and provides a power source with virtually zero interruption. - Page 9 Operational status is indicated by a series of 3 easy to read LED’s. • Audible Alarms Actively lets you know if the unit is in battery mode, if the battery is low, or if there is an over load condition. •...
-
Page 10: Installation Instructions
Installation Instructions Inspection Inspect the UPS upon receipt. The packaging is recyclable. Save it for reuse or dispose of it properly. Ensure the UPS is physically undamaged due to transit. Placement Install the UPS in a protected area with adequate airflow, and away from direct sunlight and excessive dust. -
Page 11: Physical Appearance
Physical Appearance Front Panel Rear Panel Item Description On/Off Power Switch LED 1 - GREEN - AC Normal Status LED LED 2 - YELLOW - Battery Charging LED LED 3 - RED – Battery State of charge LED AC Power socket outlets Phone/Fax line Surge Suppressor USB Communications Port Input AC Fuse... -
Page 12: Front Panel Operational Indicators
Front Panel Operational Indicators Front Panel Indicator Operational LED 1 LED2 LED 3 Buzzer Status Description Green Yellow UPS OFF. Mains Normal. Batteries Charging. 2 second Interval UPS ON. Beeping Mains Mode Beeping every 5 Mains not present. BLINK seconds Battery Backup mode 2 beeps per i. -
Page 13: Operation
Operation • Switch On - With the UPS plugged in, press the power switch in to switch the UPS on. The UPS will perform a self-test each time it is switched on and the buzzer will beep 2 times. • Switch Off - By depressing the power switch. -
Page 14: Specification
Specification Model SBUPS600VA SBUPS1000VA SBUPS1500VA Rated Output 600VA / 360W 1000VA / 600W 1500VA / 750W power Input Characteristics Rated Input Voltage 230/240V Input Voltage Range 175 – 285 V Rated Input Frequency 50 Hz ± 10% Output Characteristics Rated Output Voltage 230V ±... -
Page 15: Maintenance
General Audible Noise < 45dBA Net Mass 6 kg 10.9 kg 12.5 kg Dimensions(mm) 162×94×320 124×382×225 Operating Temperature -10°C to +40°C Maximum Operating 95% Relative Relative Humidity Maintenance 1. With normal use, a UPS battery will last 2 to 3 years depending on the number of discharges and operating/ambient temperatures. -
Page 16: Software Installation
Software Installation In order to utilise the UPS to its full potential, the monitoring software must first be installed. Please install the software according to the following steps. For information on how to operate the software, refer to the On-CD manual When the software CD is inserted, The... - Page 17 3. Enter details as requested on this screen. Your product serial number will be on the CD envelope. Click NEXT 4. Choose the installation directory. Click Next.
- Page 18 5. Select language. English is Default. Click NEXT. 6. Software will Now Install.
- Page 19 7. Installation is now complete. Click FINISH 8. The program is now running. For information on how to operate the software, refer to the On-CD manual.
-
Page 20: Load Configure Reference
Load configuration reference UPS (VA) = PC power ATX (Watt) /0.6 + Monitor (VA) Monitor power ( reference ) 15”CRT 15”LCD 17”CRT 17”LCD 19”CRT 19”LCD 80VA 40VA 130VA 60VA 180VA 80VA... -
Page 21: Troubleshooting
Troubleshooting Problem Possible Cause Action To Take i. Battery Discharged. UPS not on & Press the POWER button ON Sleep Mode. No LED’s on ii. PCB failure Contact Service Agent Power cord lose Re-plug the power cord UPS always at battery Line voltage too high, too mode Normal condition...
Need help?
Do you have a question about the SBUPS600VA and is the answer not in the manual?
Questions and answers