Advertisement
Due to changes in the product, the
procedures stated can change. This
can take place without prior notice or
adaptation of the operating manual
and is no cause for complaint, return or
price reduction. The user is responsible
to recognise deviations between the
operating manual and the actual han-
dling of the ACE III Basic and he has to
react accordingly.
Preparation for the test
1. Install 2 pieces of AAA Alkaline
batteries (1.5V, LR03) in the battery
compartment. Remove the battery
compartment cover at the back of
the device carefully and insert the
2 pieces of AAA batteries. Mind the
battery polarity in the process (+/-).
2. For the active mode operation put
a mouthpiece on the mouthpiece
connection, which is on the side of
the device. Make sure it is attached
properly. Use a different mouthpiece
for each test person. Avoid blowing
cigarette smoke into the tester!
ACE RECOMMENDS
ALWAYS USE A NEW MOUTHPIECE
FOR EACH PERSON AND EACH TEST.
ACE ASSUMES NO LIABILITY FOR
ANY VARIATIONS IN TESTING ACCU-
RACY OR ANY RESULTING DAMAGES
THEREOF ARISING WHEN SEVERAL
PEOPLE USE THE SAME MOUTH-
PIECE FOR MULTIPLE TESTS.
DO NOT USE THE ENCLOSED
MOUTHPIECE FROM ACE SERIES,
AS DURING EACH TEST RESIDUE
OF HUMAN SECRETION, INCLUDING
BUT NOT LIMITED TO SALVIA,
BLOOD, SWEAT, WILL REMAIN IN THE
MOUTHPIECE.ALWAYS USE SAFETY
GLOVES WHEN REMOVING A USED
MOUTHPIECE.
Conducting the measurement
1. Press the power button to turn on
the device
.
*
2. The device warms up until you can
see the "blow" sign.
3. Blow through the mouthpiece into
the unit for 4 seconds until the
sounds (a "tictac" tone) concludes.
4. The result is displayed for 15 sec-
onds. If you want to test again, press
the power button after the back light
has turned off.
5. The device automatically turns off
after about 4 minutes without using it.
If you press the power button constantly for
*
2 seconds, you shortly can see the total test
counts already done with this device.
IMPORTANT: AFTER CONSUMING
FOOD, DRINKING ALCOHOL OR
SMOKING CIGARETTES, WAIT AT
LEAST TWENTY (20) MINUTES BEFORE
CONDUCTING ANY TESTS WITH ACE III
BASIC BREATHALYZER. ANY TEST
CONDUCTED PRIOR TO THE EXPIRA-
TION OF THE RECOMMENDED WAITING
PERIOD WILL RESULT IN INACCURATE
RESULTS.
If the test result is below 0.007% BAC
(= 0.07‰ or 0.035 mg/l) then the
device shows 0.000% BAC (= 0.00‰ or
0.00 mg/l) on the display. This happens
because at a low range of alcohol
concentration, there is a possibility to
measure other material in your mouth.
Only the usage of original ACE
mouthpieces
guarantees the accuracy of the
test results
guarantees 100% safety of hygiene
guarantees full warranty of this device
Advertisement
