Configuring The System - QED MusiQ RFS Instruction Manual

Installation, Configuring the System
2.7 FITTING WINDOW EMITTERS
In order for the MusiQ to control the source equipment, either by the embedded functions or the I.R. Relay, Window
Emitters must be fitted. Each Window Emitter has a lead approximately 1.5m long and is fitted into MusiQ by means
of a 3.5mm Jack Plug. The small emitter LED fits to the front of the source component by means of a sticky pad. Correct
positioning of the emitter should be checked before being attached, by sending codes through a KMM module or using
the embedded control commands from the front panel or RF handset.

3 CONFIGURING THE SYSTEM

MusiQ will work straight out of its box, however there are a number of settings that can be adjusted by altering the
CON FIG switches at the rear of MusiQ.
Note: It is particularly important to configure the address switches correctly when using more than one RFS MusiQ.
3.1 CONFIGURATION SWITCH SUMMARY
Switch No.1
Switch No.2
Switch No.3
Switch No.4
Switch No.5
Switch No.6
Switch No.7
Switch No.8
12
MusiQ User Instructions
ROOMLINK INFRA RED WINDOW EMITTER ATTACHED TO
IR WINDOW ON SOURCE EQUIPMENT
Configuration Switch Configuration Switch
Up = ON
Paging inhibit Only Page Zone A
Active EQ sound Enhanced Bass
Enhancement Zone A & Treble
Active EQ sound Enhanced Bass
Enhancement Zone B & Treble
Master/Slave MusiQ is Master
Party Mode Unit in Party Mode
MusiQ Address 1
(Used only on RF model)
MusiQ Address 2
(Used only on RF model)
MusiQ Address 2
(Used only on RF model)
SOURCE EQUIPMENT
SOURCE EQUIPMENT
Configuration Switch
Down = OFF
Paging Active in
Zone A & B
Flat Frequency
Response
Flat Frequency
Response
MusiQ is Slave unit
Zone A & B work
independently