Aluminum Wheel - Subaru LEGACY 2003 Service Manual

ALUMINUM WHEEL

WHEEL AND TIRE SYSTEM
4. Aluminum Wheel
A: REMOVAL
Refer to Steel Wheel for removal procedure of alu-
minum wheels.
<Ref. to WT-5, REMOVAL, Steel Wheel.>
B: INSTALLATION
Refer to Steel Wheel for installation procedure of
aluminum wheels.
<Ref. to WT-5, INSTALLATION, Steel Wheel.>
C: INSPECTION
Refer to Steel Wheel for inspection procedure of
aluminum wheels.
<Ref. to WT-5, INSPECTION, Steel Wheel.>
Rim runout:
Axial runout limit Radial runout limit
1.0 mm (0.039 in)
D: CAUTION
Aluminum wheels are easily scratched. To main-
tain their appearance and safety, do the following:
1) Do not damage aluminum wheels during remov-
al, disassembly, installation, wheel balancing, etc.
After removing aluminum wheels, place them on a
rubber mat, etc.
2) While vehicle is being driven, be careful not to
ride over sharp obstacles or allow aluminum
wheels to contact the shoulder of the road.
3) When installing tire chain, be sure to install it
properly not to have a slack; otherwise it may hit
wheel while driving.
4) When washing aluminum wheel, use neutral
synthetic detergent and water. Avoid using the
cleanser including abrasive, hard brushes or an
automatic car washer.
WT-6