Thank you very much for choosing Cabasse speakers. Please read these instructions carefully before setting up your speakers. SAFET Y INSTRUCTIONS Lightning - For better protection against lightning or if the device must remain unused for long stretches of time, unplug Explanation of graphical sym- the power cord and antenna jack.
Page 6
1.5 ft (50 cm) Phase away from the speaker. Cabasse centre speakers or the ones mar- In order to maintain the phase relationship and frequency balance of the ked «TV» are not concerned with this, being magnetically shielded.
e n g l i s h A) PARAMETERS ADJUSTABLE ONLY BY MEAN OF THE FRONT REMOTE CONTROL KEYBOARD : PANEL : - POWER (RC1) : subwoofer’s power switch - SOURCE : selection of the type of input/output being used : - MUTE (RC2) : RCA+HL: RCA “LOW LEVEL INPUTS”...
Page 8
Regarding a. Select « RCA+HL » as « SOURCE » in order to prevent any risk of Cabasse speakers, select the frequency in the above table. If not listed Larsen effect (whistling) here, this frequency is available on the spec sheets of the products and b.
G2) MANUAL ROOM EQUALISATION Useable humidity range : 40% to 70% This way of setting up might bring better results than the Cabasse auto- calibration system only if skilled people with specific measurement Because of technical improvements already under way in our constant equipment are involved.
Page 10
Cabasse SA - 210, rue René Descartes - BP 10 - 29280 Plouzané Tel +33 (0)2 98 05 88 88 - Fax +33 (0)2 98 05 88 99 www.cabasse.com...
Need help?
Do you have a question about the 30ND40 and is the answer not in the manual?
Questions and answers