Start And Programmes - Hotpoint ECF 87 Instruction Booklet

Start and Programmes

Choosing a Programme
GB
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see Laundry).
3. Open the door and make sure the filter is clean and in place and the water container is empty and in place (see
Maintenance).
4. Load the machine and make sure that the items are not in the way of the door seal. Close the door.
5. Press the On/Off Button
6. Select the Programmes selection that corresponds with fabric being dried by checking the Programmes table (see
Programmes) as well as the indications for each type of fabric (see Laundry).
7. Where available, choose Sensor Dry
until the desired level or time is displayed.
8. Set a delay time and other options as necessary (see The Display).
9. If you wish the buzzer to sound at the end of the programme, press the sound button
Crease Care option, this option is not available.
10. Press the START button
During the drying programme, you can check on your laundry and take out the items that are dry while the others
continue drying. When you close the door again, press START in order to resume drying.
11. During the last few minutes of Drying Programmes before the programme is completed, the final COOL TUMBLE
phase is entered (fabrics are cooled), this phase should always be allowed to complete.
12. To let you know that your programme is complete the
if the SOUND option was selected the buzzer beeps 3 times every 30 seconds for 5
your laundry out, clean the filter and replace it. Empty the water container and replace it (see Maintenance).
13. Switch dryer off using the On/Off button.
Standby mode
This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which
is enabled after about 30 minutes if no activity is detected. Press and hold the On-Off button until the dryer reactivates.
10
.
or Timed Dry
to begin. The display will show the estimated time to end.
option pressing and releasing the corresponding button
buzzer will beep 3 times and the display shows END (Note:
. If you have selected the
minutes).Open the door, take