Page 1
the electric heating company Smart WIFI Kit Installation Instructions NOTE A qualified electrician must carry out the installation of the Power Meter. The Electrical installation must comply with the current UK regulations to BS.7671. Any claim on the warranty could be invalid if these requirements have not been met.
INTRODUCTION The eco SAVE smart system allows you to program, control and monitor your eco SAVE Heaters from anywhere in the World. This can be done through a Smart Phone,Tablet or Computer when connected to the Internet. The SmatHome system has the capacity to monitor and restrict the maximum power load that can be drawn from the heating system at any given time protecting the overall power loading of the proprerty.
REQUIREMENTS Gateway: To operate the eco SAVE Smart gateway you will require a Broadband Internet Connection. The Gateway can then be connected to a free LAN port on your router using the supplied Ethernet cable. The Gateway comes supplied with a Micro USB Power Cable and 230 volt power adapter.
11. Power the gateway. When the eco SAVE Smart Gateway is first connected the device will try to communicate and link with the server, you will see a sequence of LED’s blinking on the gateway. Gateway LED Status Green off, Orange flashing one second: discovery status (device pairing).
PAIRING Once the eco SAVE Smart Gateway is connected to the Internet and fully registered, you can now pair it with the eco SAVE Heaters and the Power Meter. There are 2 ways that you can put the eco SAVE Smart Gateway into pairing mode.
ADD DEVICE - NAME - PRIORITISE - LOAD SHEDDING 1. From your Computer, Smart Phone or Tablet. Select the Devices icon . Within this section you have options to Add Device - Name - Prioritise or Set the Maximum Power of the heating system.
MAXIMUM AVAILABLE POWER Note: Installation of this device must be carried out by a competent electrician in accordance with I.E.E. Regulations for Electrical Equipment. BS:7671 Power Meter The Power Meter is a device that monitors and helps to protect the main power supply to the property.
Page 8
MAXIMUM AVAILABLE POWER Power Meter Setup After the installation of the Power Meter is complete, Pair the device with the gateway as follows: 1. From your Computer, Smart Phone or Tablet. Select the Device icon. 2. Click +Add. An Orange LED on the Gateway will start to flash. 3.
TECHNICAL CHARACTERISTICS eco SAVE Smart Gateway • Desktop or wall placement • Power supply: 5V 500mA micro USB external current adapter • Dimensions: 80x80x22mm. • RJ45 connector for Ethernet connections • Communication Frequency: 868MHz • Operating Temperature 0 ºC to 60 ºC •...
Page 12
GUARANTEE Your EHC eco SAVE Smart Gateway and Power Meter are guaranteed for 12 months from Date of Purchase. Any unauthorised repair or attempted repair will invalidate the Guarantee. You may be asked to return the product to EHC for inspection to establish whether the fault is covered under the Guarantee.