ConsoleCustoms Xbox ONE MaxFire ONE v2 User Manual

CONTENTS

Page 1: Introduction, Feature Access
Page 2: Sub Modes, Rapid Fire, Burst Fire, Akimbo, Mimic
Page 3: Default Modes, Changing Modes, Adjustable Fast Reload
Page 4: Jitter Fire, Drop Shot, Jump Shot, Automatic Sniper Breath
Page 5: Quick Scope, Auto Run, Auto Aim, Battlefield Auto Spotting
Page 6: Reflex Remapping Buttons, Comp Mode, GOW Reloads
Page 7: Adjusting and Programming Modes
Page 8: Programmable Speed Settings Table, Quick Feature Turn Off
Page 9: Advanced Feature Management
Page 10: Controller Feature Quick Reference

Introduction

The Xbox ONE MaxFire ONE v2 controller offers many features, more than you will
find on any other mod available. While there are many features on this controller,
we have developed a method of accessing them which makes it quick and easy.
On the following pages you will find information about each feature and how to
access it. Many features can be used in combination allowing greater flexibility and a
greater enhancement to your gaming experience.

Feature access

The Xbox ONE MaxFire ONE v2 controller uses the "LEFT" and "UP" directions on
the D-pad for accessing all of the controllers features. We also offer the option of
"MOD" buttons on the back of the controller. The mod buttons can be used instead
of "LEFT" and "UP" on the D-pad to allow faster access to features since you would
not need to remove your thumbs from the thumbsticks .
When enabling/disabling a feature, unless otherwise noted, you will see the White
Guide Button LED flash 1 time for enabled and 2 times for disabled.
D-PAD LEFT D-PAD UP
Pg. 1
MOD BUTTONS (optional)

Sub Modes

Several of the following controller features have sub modes. Sub modes are
modifications to the main feature. These will be explained in the description of each
feature. To change a features sub mode HOLD "UP" + "LEFT" on the D-pad, while
holding both, tap the corresponding features button to change the Sub-Mode. For
example, to change the Jitter sub mode you would HOLD "UP" + "LEFT", then TAP
"Y", the WHITE LED will flash to indicate which sub mode you are currently in. If
using the optional "MOD" buttons you would HOLD both "MOD" buttons.
or

Rapid Fire

To activate/deactivate rapid fire you can either TAP "LEFT" two times very quickly
or HOLD the "RIGHT TRIGGER" and TAP "LEFT". The WHITE LED will start flashing
indicating Rapid Fire is now activated. Repeat either of these to turn off Rapid fire.
With the Optional "MOD" follow the same procedure using that button. You can
also control how the LED flashes using the Advanced Feature Management (page 9).
+

Burst Fire

To activate/deactivate burst fire HOLD the "X" button and then TAP "LEFT". The
WHITE LED will turn on solid to indicate that burst fire is activated. The burst fire will
fire at the current speed/burst settings which can be adjusted within programming
mode. Once activated burst fire can be turned on/off using the same process as
rapid fire. To deactivate again hold "X "and tap "LEFT".

Akimbo (Dual Trigger Rapid Fire)

To activate/deactivate akimbo HOLD the "LEFT TRIGGER" and TAP "LEFT. With
akimbo activated you will have rapid fire on both the left and right triggers
(independently), this is great for akimbo or dual weapons in Call of Duty and other
FPS games.

Mimic (Auto Akimbo)

To activate/deactivate HOLD the "RIGHT TRIGGER" and TAP "UP". When using
mimic , the right trigger controls both the left trigger and the right trigger at the
same time. If the akimbo is activated and rapid fire is turned ON than the left trigger
will also rapid fire, otherwise it works as normal allowing you to scope
automatically when firing.
+
HOLD
+
HOLD +
HOLD
+
Pg. 2