Do you have a question about the RCT-3 and is the answer not in the manual?
Questions and answers
Summary of Contents for SOLAR BRAND RCT-3
Page 1
ELECTRONIC REMOTE CONTROL SYSTEM SOLAR Brand OWNER’S MANUAL SOLAR BRAND REMOTE CONTROL CURTAIN MODEL RCT-3 REMOTE CONTROL AND USER –OPERABLE SWITCH 2 IN 1 For fully enjoy your set from very beginning, read this manual carefully and keep it handly for future reference.
Thank you for purchasing a “Solar Brand” Electronic Remote Control Curtain System. 1. Introduction This Electronic Remote Control Curtain System is combined by aluminium track and driving units. Two in one control system allows the user to operate either by remote control or user-operation switch. A pair of curtains may move together or apart during opening and closing respectively, and a single curtain may move in a single direction.
6. Assembly Feature 1. Big End Bracket 10. Overlap-Arm 2. Bearing 11. Aluminium Track 3. Adjusting Screw for S/S Wire 12. Carriage B 4. Button for Motor Catch Hold of 13. Screw for S/S Wire of Carriage B 5. Bracket Holdfast 14.
Page 4
7. Let carriage A & B slide into aluminium track. Tie both end of S/S wire and put big end bracket & small end bracket into aluminium track. 8. Loose the adjusting screw for S/S wire as more as possible. 9.
Page 5
8. Motor Installation Plug In Take Down Plug the motor into the big end Press the button by the index bracket with 45°. The index finger finger and turn the motor to 45° should press the button, and turn and release the motor. The motor to a right angle.
Page 6
FIG 1: A track and B track connection Specification Of Wall Mount Control Broad (Infrared Receiver) Press the button on wall mount control broad may control the curtain open or close directly. Buttons of A group can control A track. Buttons of B group can control B track.
Page 7
A Guide To Simple Problem Solving: Before calling service personnel, please check the following chart for a possible cause to the trouble you are experience. SYMPTOM CHECK THIS THING SOLUTION Power is not turned on The power cord is not plugged in. Plug the power cord in Remote Controller does not work The batteries in the remote Replaced by new batteries.
Need help?
Do you have a question about the RCT-3 and is the answer not in the manual?
Questions and answers