Download Print this page

CEN-TECH 61652 Owner's Manual And Safety Instructions page 4

6/12 volt circuit tester with 5ft lead
Hide thumbs


Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
Disconnect the Circuit Tester from all power sources before performing
any inspection, maintenance, or cleaning procedures.
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general condition
of the tool. Check for loose hardware, misalignment
or binding of parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may
affect its safe operation.
Do not use damaged tools.
Changing the Bulb
1. To change the Bulb, remove the
Cord Clamp from all power sources.
2. Unscrew the Tail Base from the
Handle, and remove the Spring.
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards,
and warrants to the original purchaser that this product is free from defects in materials and workmanship for the
period of 90 days from the date of purchase. This warranty does not apply to damage due directly or indirectly,
to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity, improper
installation, normal wear and tear, or to lack of maintenance. We shall in no event be liable for death, injuries
to persons or property, or for incidental, contingent, special or consequential damages arising from the use of
our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation of exclusion may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER
To take advantage of this warranty, the product or part must be returned to us with transportation charges
prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise.
If our inspection verifies the defect, we will either repair or replace the product at our election or we may
elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will
return repaired products at our expense, but if we determine there is no defect, or that the defect resulted
from causes not within the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • 1-888-866-5797
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Unscrew the Bulb from the Spring and
replace with a new 12V/3W Bulb.
4. Replace the Spring and Bulb in the
Handle and screw in the Tail Base.



  Related Manuals for CEN-TECH 61652