DTT SYSTEM PERFECT SUN 32P Manual

Advertisement

Quick Links

DANGER
Ultraviolet radiation. Follow instructions. Avoid overexposure. As with
natural sunlight, overexposure can cause eye and skin injury and
allergic reactions. Repeated exposure may cause premature aging of the skin and skin cancer.
WEAR PROTECTIVE EYEWEAR; FAILURE TO MAY RESULT IN SEVERE BURNS OR
LONGTERM INJURY TO THE EYES. Medications or cosmetics may increase your sensitivity
to the ultraviolet radiation. Consult physician before using sunlamp if you are using medications
or have a history of skin problems or believe yourself especially sensitive to sunlight. If you do
not tan in the sun, you are unlikely to tan from the use of this product. Children, the elderly, or
fair skinned people who always burn easily and either never tan or tan minimally should not use
this equipment.
To use, lie down on bench and pull canopy down as far as adjustment will allow maintaining
at least 2 inches (5.1 centimeters) between your body and canopy clear plastic panel, other-
wise overexposure may occur. Do not use without clear plastic panels in place. Untanned per-
sons should not tan on consecutive days during their first week of tanning. Never tan more than
once a day. Tanning normally appears after the first few sessions and maximizes after approxi-
mately four weeks. Tan once or twice per week thereafter to maintain appearance. Persons
already having a base tan may begin at advanced levels corresponding to the extent of their
base tan.
Skin Type:
I
Sensitive Skin (Burns easily and severely and does not tan.)
II Light Skin
(Burns easily and severely and tans minimally.)
III Normal Skin
(Burns moderately and tans average.)
IV Dark Skin
(Burns minimally, tans easily and above average.)
RECOMMENDED EXPOSURE TIMES IN MINUTES
Level 1/Week 1
Skin Type: 1st-3rd Sessions
I Sensitive
II Light
3
III Normal
4
IV Dark
5
MAXIMUM EXPOSURE TIME IS 17 MINUTES
New lamps emit approximately 10% more ultraviolet radiation during the first 50 hours of
operation. Recommended tanning times should therefore be reduced by approximately 10%
during that period.
WARNING: • Read these instructions before using this sunlamp product. • All persons in the
room should wear protective eyewear when lamps are on. Recommended eyewear: provided
eyeshields or equivalent eyewear as defined under 21 CFR 1040.20. Other types of eyewear
may not provide adequate protection. Failure to use protective eyewear may result in severe
burns or other eye injury. If discomfort develops, discontinue use and consult a physician.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THE 32P:
DARK TAN® II Wolff® Model DTII 71-T12 100W BI-PIN
XS-Power Wolff® Model XSP71-T12-100W BI PIN
DARK TAN® Wolff® Model DT71-T12-100W BI-PIN
DARK TAN® Dual Twist Model DTDT 71-T12-100W BI-PIN
XS-Power Dual Twister ™ Voltarc ® Model XSPDT71-T12-100W BI PIN
XS-Power 2 Tone Twist Model XSP2T 71-T12-100W BI-PIN
DISCONNECT POWER CORD BEFORE ATTEMPTING TO CLEAN, RELAMP, OR
ENGAGE IN THE MAINTENANCE OF THIS PRODUCT.
THIS EQUIPMENT MUST BE EARTH GROUNDED.
This product is in conformity with performance standards
for sun lamp products under 21 CFR PART 1040.20 and
ANSI/UL Standard 482.
88465
Level 2
Level 3
Level 4
Level 5
NOT RECOMMENDED FOR TANNING
6
10
14
7
11
15
9
13
17
(
below)
(
below)
(
below)
( below)
( below)
Shock hazard.
Disconnect power before servicing or removing any protec-
tive covers.
Do not operate this device near water or while you are wet.
Some medications may increase your sensitivity to ultraviolet light. It
is recommended that you consult a physician before using this
sunbed if taking any medication or if you suspect that your skin might
be especially sensitive to sunlight.
Wear protective eyewear.
Failure to may result in severe burns or longterm injury to the eyes.
Air from the room is used to cool the sunbed. Maximum ambient room
temperature should be 80°F. Place your sunbed no closer than 6" from
any wall. Make sure nothing obstructs the airflow into the sunbed's
endcaps or out of the fan openings. A poorly ventilated room may
cause the unit to become hot and cause discomfort to the user.
17
17
Electrical Requirements
17
Your sunbed operates from a 120V AC source. You should have a
NEMA 5-20R electrical outlet (below), on a dedicated circuit capable
of providing 20 Amp service, installed in the room in which you will
use the unit. We recommend installation by a professional electrician.
The outlet must be earth grounded.
Unpacking and Inspection
The canopy box contains the canopy, a pair of gas springs, assembly
hardware and the skirt. The bench box contains the bench and the
( below)
stand legs. Inspect the items and make sure they are free from any vis-
ible damage. Report the extent of any damage to the transportation
company.
DANGER
DANGER
WARNING
CAUTION
20 AMP NEMA #5-20R
RECEPTACLE
30198-01A - Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PERFECT SUN 32P and is the answer not in the manual?

Questions and answers

Summary of Contents for DTT SYSTEM PERFECT SUN 32P

  • Page 1 DANGER Ultraviolet radiation. Follow instructions. Avoid overexposure. As with DANGER natural sunlight, overexposure can cause eye and skin injury and Shock hazard. allergic reactions. Repeated exposure may cause premature aging of the skin and skin cancer. WEAR PROTECTIVE EYEWEAR; FAILURE TO MAY RESULT IN SEVERE BURNS OR Disconnect power before servicing or removing any protec- tive covers.
  • Page 2: Hardware Inventory

    Hardware Inventory Assembly Procedures (These items, Velcro® and a small pillow) Lay the bench upside down on the Allen-head Bolt 5/16” x 1” Hinge Brackets floor. Locate the two stand legs. Quantity 2 (1) left, (1) right SKIRT MOUNTING HOLES 5/16”...
  • Page 3: Front Skirt

    The front skirt panel is held in place by adhesive backed Velcro® strips. Clean each place the adhesive will touch with rubbing alcohol (see right). Peel off the backing paper VELCRO STRIPS from the two large pieces and adhere them to the stand legs. Stick a long, narrow strip on each side of the side skirts in the indentation.
  • Page 4 Lift the canopy and hold it between the hinge brackets. Insert 5/16” x 1 1/2” bolts with nylon washers into both hinge brackets. Tighten bolts into the endcap threaded inserts until snug, then an additional half turn. Do not overtighten to avoid damaging threaded inserts.
  • Page 5 Using Your Sunbed Operation This sunbed is equipped with a control key lock on the timer bezel, Before using your sunbed, please note the following: allowing you to monitor usage by children and/or others. To activate, insert the key into the lock and turn, horizontal to lock and vertical to •...
  • Page 6 Care and Maintenance Removing/Replacing Acrylic Shields The acrylic shields are secured in place by hinged profiles which run Cleaning After Use the length of the bed, both front and back. Simply pry up on the inside Clean and disinfect your tanning bed’s bench and canopy after each edge of the profile until it releases its latching action (see figure use.
  • Page 7: Troubleshooting

    Troubleshooting Problem Solution Sunbed not tanning 1. Clean sunbed, see Thorough Periodic Cleaning. 2. Replace lamps if lamp hours are greater than 800hrs. 3. Replace acrylic. Lamps fail to light and timer display is blank 1. Check source of AC power. Reset circuit breaker or replace fuse if necessary.
  • Page 8 Perfect Sun® 18 MONTH WARRANTY Perfect Sun® warrants your tanning unit to be free of structural defects in material and work- manship, under normal use, for its lifetime. Perfect Sun® will, at its discretion, repair any structural defect which materially affects the performance of the tanning unit, or replace the tanning unit.

Table of Contents