Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BluStream HSP14AB-V2
Summary of Contents for BluStream HSP14AB-V2
- Page 1 70m 4-Way HDBaseT™ Splitter - HDCP 2.2 Upgrade HSP14AB-V2 HSP14AB-V2 User Manual...
- Page 2 Do not substitute or use any other power supply other than the enclosed unit, or a Blustream approved replacement. Do not disassemble either the Transmission or Receiver units for any reason. Doing so will void the manufacturer’s warranty.
- Page 3 HDMI source to four simultaneous HDBaseT™ outputs with HDCP2.2 support. It transmits HDMI, bi-directional IR and PoH (PoE) up to lengths of 70m over a single CAT cable to compatible Blustream receivers. The 4-way splitter also features a HDMI loop-out, audio breakout and EDID management.
-
Page 4: Front Panel
IR input - 3.5mm stereo jack. Transmits IR to the zone HDBaseT™ receivers (displays) IR output - 3.5mm mono jack. Connect to Blustream 5V IR emitter for source control from remote areas Coaxial audio out - RCA connector, de-embedded audio from the HDMI input L/R audio out - 3.5mm stereo jack, de-embedded audio from the HDMI input. - Page 5 When installing CAT cables it is advised that you use the best possible CAT cable quality possible. HDMI distribution products will only work if used with CAT5e standard cable or above. Blustream recommends using a CAT6 cable for your installations, especially when running over longer distances, in areas of high EMI, or for 4K signal distribution.
-
Page 6: Edid Control
By pre-determining the video resolution and audio format of the source and display device you can reduce the time needed for EDID hand shaking. Configuration of EDID settings can be achieved using the product dip-switches on the end of the HSP14AB-V2. EDID dip-switch settings are shown below. - Page 7 USER MANUAL Infrared (IR) Distribution The Blustream range of HDBaseT™ products include multiple options for control and routing of IR. IMPORTANT: Blustream Infrared products are all 5V and NOT compatible with alternative manufacturers Infrared solutions. When using third party 12V IR control solutions please use supplied Blustream IRCAB cable for IR conversion (sold separately).
- Page 8 HSP14AB-V2 USER MANUAL 70m max contact support@blustream.co.uk / support@blustream.com.au...
-
Page 9: Specifications
• Video output: 4x HDBaseT™ RJ45 connector, 1x HDMI Type A, female • Audio output:1x 3.5mm L/R analogue audio & 1x digital coaxial (RCA) • PoH (Power over HDBaseT™) supplied to compatible Blustream HDBaseT™ receivers from the splitter • IR input: 1x 3.5mm stereo jack •... - Page 10 www.blustream.com.au...
Need help?
Do you have a question about the HSP14AB-V2 and is the answer not in the manual?
Questions and answers