Related Manuals for EarthQuake MB1
Summary of Contents for EarthQuake MB1
- Page 1 The Sound That Will Move You MB1 Digital Bass Synthesizer Installation Manual Earthquake Sound Corporation 2727 McCone Avenue Hayward CA, 94545. USA US Toll Free: 1-800-576-7944 | Tel: 510-732-1000 | Fax: 510-732-1095 www.earthquakesound.com...
-
Page 2: Table Of Contents
Set your audio system to a comfortable loudness level. Earthquake Sound Corporation does not assume liability for damages resulting from the direct use of Earthquake amplifiers or other Earthquake products, and urges users to play their music at moderate listening levels. -
Page 3: Care And Maintenance
4. The speakers and/or speaker enclosures Keep the bass synthesizer dry. If it gets wet, wipe it dry Due to the variations in the recording process, the MB1 is engineered with immediately. Liquids contain minerals that can corrode electronic amazing features to help restore any low frequencies lost during the process or circuits. -
Page 4: Mb1 Overviews
MB1, plug the connector back to the MB1. BASS CONTROLS The WIDE knob adjusts how wide of a frequency range the MB1 will affect. The SWEEP knob allows you to pick the center frequency (between 27Hz and 63Hz) that you want the MB1’s restoration circuit to maximize. -
Page 5: Mb1 Overviews
Not all systems are designed the same way, some systems are WARNING: Failure to disconnect the negative terminal of your battery prior to designed strictly for SPL while others are for average use. The MB1’s installation may result in sever shock and/or damage to the maximizer circuit can either increase or decrease the signal voltage of components in your system. -
Page 6: Installation & Wiring Configuration
MB1 MEGA BASS Digital Synthesizer needs to be installed in the signal path If you are using an equalizer, connect the MB1 to the SUB OUT of the as close as possible to the source unit (between a head unit and an external equalizer and use it to drive the bass amplifier, as shown below. -
Page 7: Adjusting The Bass Output Setting
ADJUSTING THE BASS OUTPUT SETTING REMOTE IN The MB1 is the most powerful bass component on the market. It is able to Connect a 22-gauge to 18-gauge wire from the head unit’s remote turn-on to dramatically enhance any audio system to audiophile preference status. It is the REMOTE-IN connector of the MB1. -
Page 8: Specifications, Factory Settings & Options
SPECIFICATIONS, FACTORY SETTINGS & OPTIONS Maximum Input Level......... 15 Vrms Adjustable Settings Factory Setting Other Options Maximum Output Level......13.5 Vpeak Bass Frequency.... 40Hz....... 27Hz - 63Hz Frequency Response........ 10Hz - 80kHz ±0.3dB Bass Bandwidth.... Wide....... 30Hz - 250Hz Total Harmonic Distortion......0.001% Bass Output Setting.. -
Page 9: Troubleshooting
When the system is playing but there is no difference in the sound/bass, try turning the dash remote knob clockwise. If there is no change, then make sure that the MB1 is installed in the right part of the signal path. SOUND IS DISTORTED... -
Page 10: Warranty Guidelines
In most cases, our technicians might be able to resolve the problem over the phone, thus (C) Earthquake agrees to repair or replace - at our option - all such defective eliminating the need to ship the product. - Page 11 Ship product to: Earthquake Sound Corp. 2727 Mc Cone Avenue Hayward, CA 94545 You are responsible for the cost of shipping the product to Earthquake Sound Corporation. (G) Disputes Resolution: All disputes - between clients and Earthquake Sound Corporation - resulting from the five (5) years limited warranty policy must be resolved according to the laws &...
- Page 12 The Sound That Will Move You Copyright © Earthquake Sound Corporation Earthquake Sound reserves the right to amend details of the specifications without notice.