7. Spray gun 8. Pump 9. Battery 2.Specifications Item number GW5401 & GW5401-C Maximum Pressure 4200 PSI Horese Power 13 HP 3600 RPM Electric Starter 3. Safety instruction: The appliance is intended to clean cars, garden and roof etc. Never attempt to use power washers on or near any electrical outlets, fuse boxes, transformers, high voltage wires, etc.
Electric Pressure Washer PLAN AHEAD 1. Always wear ear protection to cut noise and eye protection and / or face shield to prevent debris from flying or ricocheting into eyes and face which could result in serous injury. 2. Dress safely in long pants and wear safety boots, safety gloves, safety helmets with visors, etc. Other protective equipment is advisable when using chemicals, cleaning detergents or other corrosive or abrasive substances.
Owner’s Manual any repairs of your pressure cleaner. Failure to do so may result in injury or cause hazardous operating conditions to exist. WATER SUPPLY (Cold Water Only) Water hose must be at least 3/4 inch in diameter. Flow rate of water supply must be more than 1MPa. The water supply temperature must not exceed 147.6℉(50℃).
Page 5
Electric Pressure Washer 5.1 Assembly Step1. Attach the handles to the frame of the pressure washer. Insert bolts and tighten with knobs. Step 2. For the machines with hose reel: Attach the hose reel to the handle of the machine. Align holes insert bolts, and tighten with screws.
Page 6
Owner’s Manual If your machine have interchangeable nozzles (see next point), make sure using the black one, soap nozzle is installed. Soap injectors will not work when high pressure nozzles are installed. If your machine have an adjustable nozzle (see next point), be sure it is in the low pressure position to draw soap.
Page 7
Electric Pressure Washer • Removing marine growth from boats and marine equipment. • Removing rust from steel and oxidation from aluminum. C. 40 DEGREE- WASHING • Light cleaning and washing. • Washing and rinsing of automobiles and boats. • leaning roofs, windows, patios and driveways. - The operating pressure and flow for each nozzle Nozzle 0 degree...
Page 8
Owner’s Manual 2) Start engine according to the engine owner’s manual. 3) Press the trigger of high pressure gun to make sure water flowing out. In emergency condition: Turn engine off. 5.4 Shut Down Procedure Release the trigger can stop the water flowing out. After did this, pls. engage the trigger safety lock to avoid accidental “switch on”.
Electric Pressure Washer as a safety device to guard against failure of pump parts, and the development of dangerously high pressures. 6. Maintenance and Cleaning : When doing maintenance, you may be exposed to hot surfaces, water pressure, moving parts, or fire resulting in death.
Page 10
Owner’s Manual Water leaking at pump Loose connections. Tighten. NOTE: Little leaking at pump outlet is normal. Oil leaking at pump Oil seals worn. replaced Pump overfilled. Check for correct amount. Incorrect oil used * Drain and fill with correct amount and type of oil.
Page 11
Electric Pressure Washer t l o GW5401-02-YG Gasket φ t l o...
Page 12
Owner’s Manual GW5401-05-YG Gasket φ GW5401-11-YG Spring Gasket φ t l o t l o Under Frame t l o t l o GW5401-23-YG Spring Gasket φ GW5401-24-YG Gasket φ Clip Spring Shaft GW5401-28-YG 10” Wheel Ringφ16 Insert Retainer Under Bottom Gun Hook Battery Rubber Foot GW5401-33-YG Battery...
Owner’s Manual Limited Warranty Gentron® warrants to the original purchaser who uses the product in a consumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase.
Owner’s Manual(s) supplied with the product, improper maintenance, the use of accessories or attachments not recommended by Gentron®, or unauthorized repair or alterations. • Repair and transportation costs of merchandise determine not to be defective.