1. Manuals
  2. Brands
  3. Surge master Manuals
  4. Log Splitter
  5. SE50
  6. Assembly instructions manual

Surge master SE50 Assembly Instructions Manual

Trailer woodsplitter
Hide thumbs Also See for SE50:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

See also: Operator's Manual
TRAILER WOODSPLITTER
MODEL SE50
ASSEMBLY INSTRUCTION MANUAL
Please review and understand the
operators manual before attempting
to operate this machinery.
EMB MANUFACTURING INC.
4144 BOOMER LINE
ST. CLEMENTS, ON
N0B 2M0 CANADA
PH: (519) 699-9283
FAX: (519) 699-4146
PRINTED IN CANADA
REV 171111
PART NUMBER: Z97503

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SE50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Surge master SE50

Summary of Contents for Surge master SE50

  • Page 1 TRAILER WOODSPLITTER MODEL SE50 ASSEMBLY INSTRUCTION MANUAL Please review and understand the operators manual before attempting to operate this machinery. EMB MANUFACTURING INC. 4144 BOOMER LINE ST. CLEMENTS, ON N0B 2M0 CANADA PH: (519) 699-9283 FAX: (519) 699-4146 PRINTED IN CANADA...

  • Page 2: Bolt Torque

    ASSEMBLY SAFETY 1. Read and understand the Assembly Manual and all safety signs before starting. 2. Follow good safety practices: Keep service area clean and dry. Be sure electrical outlets and tools are properly grounded. Use adequate light for the job at hand. 3.
  • Page 3 ASSEMBLY The machine is shipped from the factory in a partially disassembled configuration and at- tached to a pallet that provides easy moving and handling. Always use tools, equipment and fork lifts of appropriate size and capacity for the job. When the machine is shipped, follow this procedure when preparing for the cus- tomer:...
  • Page 4 6. Remove the screws securing the compo- nents to the pallet lay out. Support Leg Support Bracket (Cylinder Frame) Fig. 3 COMPONENTS 7. Open fastener box and remove the bag of fasteners. Open Box Fig. 4 FASTENERS 8. Turn the frame at 90° to the axle. Fig.
  • Page 5 9. Secure cylinder frame to axle tank with 4 bolts. Tighten fasteners as specified on the torque chart (pg 2). 10. Undo the bolt that holds the support leg to Securing Frame to Axle Tank the tongue channel. Remove the leg from the tongue channel.
  • Page 6 12. Install hitch, taking care to insert safety transport chains individually over each bolt. Install Hitch, Bolts, and Chains Fig. 8 HITCH HARDWARE Remove Fasteners from Axle Shipping Brackets 13. Support the axle to prevent it from drop- ping unexpectantly, then carefully remove shipping brackets to free the axles from the pallet.
  • Page 7 15. Slide cylinder backwards until it contacts the collar stop. Rotate cylinder, if necessary, to position valve to preferred operating angle. Saddle 16. Place the saddle on top of the cylinder collar mount as shown, align the bolt holes and insert the 1/2 x 1 1/2 bolt through the saddle (one on each side) Assemble 1/2"...
  • Page 8 Carefully insert the pivot pin. 21. Using needle nose pliers, secure the pivot pin by re-inserting the cotter pin. Test the function of the handle to ensure everything is assembled properly. Congratulations on successfully completing assembly of SE50 Woodsplitter...

Table of Contents