Bosch BGL3A330GB Instruction Manual page 5

Table of Contents

Advertisement

Safety information
Do not operate the vacuum cleaner if it is damaged.
Unplug the appliance from the mains if a fault is detect-
ed.
For safety reasons, only authorised after-sales service
personnel are permitted to carry out repairs and fit
replacement parts to the vacuum cleaner.
Protect the vacuum cleaner from the weather, mois-
ture and sources of heat.
Do not pour flammable substances or substances con-
taining alcohol onto the filters (dust bag, motor pro-
tection filter, exhaust filter, etc.).
The vacuum cleaner is not suitable for use on con-
struction sites.
=> Vacuuming up building rubble could damage the
appliance.
When not in use, switch off the appliance and pull out
the mains plug.
At the end of its life, the appliance should immediately
be rendered unusable, then disposed of in an appro-
priate manner.
!
Please note
The mains socket must be protected by at least a 16
amp circuit breaker.
If a circuit breaker is tripped when you switch on the
vacuum cleaner, this may be because other electrical
appliances which have a high current draw are con-
nected to the same power circuit.
To prevent the circuit breaker from tripping, select
the lowest power setting before switching the appli-
ance on, and increase the power only once it is run-
ning.
Notes on the energy label
This vacuum cleaner is a general purpose vacuum
cleaner with a primary hose.
To achieve the declared energy efficiency and cleaning
performance class on carpet, please use the inter-
changeable universal nozzle.
To achieve the declared energy efficiency and cleaning
performance class on hard floor with nooks and cran-
nies, please use the hard floor nozzle provided.
These calculations are based on the Commission
Delegated Regulation (EU) No. 665/2013 of 3rd May
2013 supplementing Directive 2010/30/EU.
Unless otherwise stated, all the procedures referred
to in these instructions were carried out in accor-
dance with the EN 60312-1:2017* standard.
*As the motor service test is carried out with the dust
collector empty, the stated motor service life must be
increased by 10% for tests with the dust collector half
filled.
5

Advertisement

Table of Contents
loading

Table of Contents