Summary of Contents for Hutong MIG-210Y
- Page 1 MIG Series Tapped Gas Shielded Welder Operation Instructions (Attention: please carefully read the operation instructions before use)
- Page 2 Please carefully read these operating instructions before using the welding machine. The operating procedures recommended in this operating instruction manual must be strictly followed in trail-operation. I． Main Application and Suitable Scope MIG series CO Gas Shielded Semiautomatic Arc-Welding Machine (hereafter referred to as “Welding Machine ”) is applicable to CO gas shielded welding of sheet metal, mediate plate and thick plate of various common carbon steel, high grade carbon steel and low alloy steel.
- Page 3 III. Specification and Technical Parameter Model MIG -210Y MIG -250Y MIG -270Y MIG -350Y MIG -400Y MIG -500Y Primary voltage(V) 380V/50Hz 380V/50Hz 380V/50Hz 380V/50Hz 380V/50Hz 380V/50Hz Phase Rated load 15.5 endurance(kVA) Secondary nonloaded 18.0V~30.0 18.0V~32.0 19.5V~34.5 21.5V~37 22V~43 22~52 voltage(V) Current Adjusting 40~210 40~250...
- Page 4 Ⅳ．Panel Sketch 1．Protection indicator 2．current adjustment Tapped Gas Shielded Welder 3．Power switch MIG-270Y 4．Voltage switch 5．Power supply indicator 6．Spot welding regulation 7．Intermittent regulation 8． Adapter of Welding Torch 9． Output Ports V．Systematic Demonstrations 1．Installation and debugging ※ VA welding machine shall be installed at a steady and well-ventilated place. The sunlight shall be shielded when using outdoor.
- Page 5 2) Install the wire reel winded with welding wire to the axle of wire feeder, adjust the wire feeding wheel and contact tip according to the diameter of the welding wire, and deliver the welding wire into the wire delivery hose and well press the wire feeding wheel. 3) Open power of the welding machine and adjust the switch for “Voltage Regulation”...
- Page 6 4. Replace the contact tube and spray head on timely so that the welding torch or welding machine is not damaged. 5. The greasy dirt or others on the wire feeding wheel and wire tail shall be timely cleaned. and the wire feeding wheel of which the V groove is seriously worn shall be timely replaced so as to prevent instable and slipping wire delivery.
- Page 7 MIG -210/250/270/350/400/500 Electric schematic diagram －6－...
Need help?
Do you have a question about the MIG-210Y and is the answer not in the manual?
Questions and answers