Operating The Monitor - Hitachi HILU75202 Installation Manual

Ultra hd interactive flat panel display
Hide thumbs Also See for HILU75202:
Table of Contents

Advertisement

4  Operating the monitor
The control panel of the monitor
Remote Control
Receiver
1
2
3 4
1: LED Indicator
Power Status
Blue
Red
Off
2 : USB
3 : Touch USB(for Laptop PC)
4 : HDMI IN (Connected to External)
Important Notice
The USB cable (5 m) that Hitachi provides in this accessory box is
for use of connection to Touch USB at the back. Therefore, in case
of connecting USB cable to Touch USB in front, separate USB cable
is required and the length of cable is strongly recommended to be
less than 3 m to make sure signal intensity of touch sensor work
properly.
The Remote Control (RCU) Instructions
No. Function
1
Power
Source
2
▲, ◀, ▶, ▼
3
Menu
Exit
Freeze
Volume +
Volume -
Mute
Condition
Power on
Power off(stand-by)
AC off
Description
Turns the monitor On and Off
Select source (PC, HDMI 1,
HDMI 2, HDMI 3 Displayport)
Navigates through submenus and
settings
Open the menu
Closes the menu system
Freezes the current source image
Increases the sound volume
Decreases the sound volume
Turns off the sound
1
3
Display Mode
Turning the monitor on
1. Correctly insert the power cord into the monitor and
into the power socket
2. Press the power button on the remote or front control panel.
Turning the monitor off
With the power on, press the power button on the remote or
front control panel to place the monitor in a standby mode. To
turn off power completely, disconnect the AC power cord from
the power outlet.
Adjusting the Volume
1. Using the remote, press the VOLUME+ or VOLUME- to increase
or decrease the volume.
2. Press the MUTE button to temporarily turn off all sound.
To restore the sound, press the MUTE button again.
Selecting the input source
1. Using the remote, press the desired source button (PC, HDMI 1,
HDMI 2, HDMI 3, DP)
2. Or press SOURCE on the monitor keypad, and toggle the source
button until you have reached the desired source, and press
ENTER
PC
HDMI 1
HDMI 2
HDMI 3
DP
3. If the monitor cannot find a source, a "No signal" message
will appear.
2
Battery insertion
5

Advertisement

Table of Contents
loading

Table of Contents