Download Print this page

Nishi Musen Kenkyusyo NTS220 Operating Manual

Qrp 144mhz ssb/cw transceiver

Advertisement

Quick Links

O p e r a t i n g M a n u a l
N I S H I
INTRODUCTION
1
The NTS220 is a QRP 144MHz SSB/CW Transceiver. Its small size and light weight are
ideal for portable use. The NTS220 has been carefully engineered and manufactured to be
reliable and efficient. If you experience any problems or questions, please contact us so
assistance can be provided.
SUPPLIED ACCESSORIES
2
External power connection cable
Connection cable for CW KEY
Connection cable for Handy Microphone Speaker(HM-75 type connection available)
AA batteries (4 pieces)
Warranty

SPECIFICATIONS

3
Frequency Range :
Emission Modes:
RF Power Output:
Oscillation method:
stability±2.5ppm. Receiver Incremental Tuning.)
Sensitivity:
Receiving method:
Supply Voltage:
Power consumption:
Aerial Impedance:
Operating Temp. Range: -10 °C to +60 °C (+14 °F to +122 °F)
Dimensions:
Weight:
Display Backlight:
RX signals.
144MHZ SSB/CW Handy Tranceiver
N T S 2 2 0
M U S E N
K E N K Y U S Y O
144000.00~144999.95KHz
SSB(USB)、CW(Side tone & Semi-break-in)
1W(Max)
PLL(0.05KHz/Step + FUNC key 2.5KHz/Step. Frequency
Under 0.15μV(SINAD12dB)
Single superheterodyne
6VDC(4 internal AA alkaline batteries)
RX 80mA(standby - no signal) TX 250~700mA Max.
50 ohms(SMA)
78W x 27H x 140D mm
300g(incl. batteries)
Display has illuminated backlighting active during incoming
(in Eng. ver.04)
C O . , L T D

Advertisement

loading

Summary of Contents for Nishi Musen Kenkyusyo NTS220

  • Page 1: Specifications

    C O . , L T D INTRODUCTION The NTS220 is a QRP 144MHz SSB/CW Transceiver. Its small size and light weight are ideal for portable use. The NTS220 has been carefully engineered and manufactured to be reliable and efficient. If you experience any problems or questions, please contact us so assistance can be provided.
  • Page 2: Sp&Mic Jack

    4 Each part name 1 PWR switch 2 PWR LED 3 VOL+ switch 4 RIT+ switch 5 FRQ+ switch 6 SP&MIC jack 7 PTT switch 8 External KEY terminal 9 CW KEY switch 10 SQL switch 11 FRQ- switch 12 RIT- switch 13 VOL- switch 14 ANT connector(SMA) 15 FUNC switch...
  • Page 3: Receiver Operation

    8 RECEIVER OPERATION a) Basic operation ① ② ③ ⑤ Press and hold in the PWR switch(1) for one second to turn to the transceiver ON or OFF. When the PWR switch and FUNC switch(15) are pushed at the same time, the frequency becomes an initial state.(144250.00KHz、RIT+00) ⑮...
  • Page 4: Adjusting The Squelch

    d)RIT (Receiver Incremental Tuning) Adjust the 'receive offset' higher or lower with RIT+ ④ key(4) or RIT- key(12). This will not change the TX frequency – only the RX frequency will change. The RX frequency steps in 0.05KHz increments with a 15 step maximum range(±0.75KHz). ⑫...
  • Page 5: Transmitter Operation

    TRANSMITTER OPERATION ② ⑦ a)SSB TRANSMISSION Press the PTT switch(7) , and speak into the microphone to transmit a SSB signal. When the PTT switch is pushed, the PWR LED(2) turns on. An external microphone can be used by using the provided converter cable to attach to the radio.
  • Page 6 NISHI MUSEN KENKYUSYO CO.,LTD. since 1986 Leven Sannomiya Building Room#205, 2-1-29 Kumoidori, Chuou-Ku Kobe City, Hyogo Prefecture 651-0096 Japan Phone: +81-78-251-8721 Fax: +81-78-251-8722 nishi@nishimusen.co.jp We at Nishi Musen Kenkyuujyo Co.,Ltd. are highly skilled in developing various radio instruments. Especially we have good techniques to design analog circuits for radio.
  • Page 7 (e) Wireless units, Ultrasonic sensor, IR sensor...