Wall Mounting; Status Light - Doro rp2001x User Manual

English
Installation
Please note!
Do not place the repeater close to other electrical equipment such as TV sets, computer screens, telecom
equipment, fans etc. This will minimise the risk of interference. Do not place the repeater in areas where
it will be exposed to direct sunlight or other major heat sources.
Do not install the repeater where it will be subject to rain or get wet. For use outdoors a covered location
is recommended.

Wall mounting

1. Fix two screws positioned horizontally 34mm apart.
2. Place the repeater over the screws and slide downward into place.
Protection from dust and water
The repeater complies with IP-53, which means it is protected from ingress of dust
and water splashes. This does not indicate the unit is "waterproof" it therefore must be
protected from rain and direct sunlight when installed outdoors.
This compliance does not apply to the electrical adapter; this must be positioned so that
it is protected from water and dust.

Status light

The light on the repeater is used to indicate the operational status of the unit.
Steady light - Call connected through the repeater
Pulse flashing - Registration mode
Slow flashing - Standby mode when registered to a base unit
Rapid flashing - Not registered to a base unit
Light off - No electrical power supply to the repeater
www.doro.com 3