Advertisement
Quick Links
Advertisement
Summary of Contents for Soltech Lounge
- Page 1 SolTec™ Lounge Operators Manual SolTecWellbeing.com...
-
Page 2: Fcc Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. - Page 3 Table of Contents Assembly Instructions Pages 4 - 8 Operating Instruction Pages 9 - 10 Music Input Connection Options Page 11...
- Page 4 When you remove the seat section from the carton, please place it on the floor pad-side down as shown below. Never place the Lounge on its side with the amplifier against the ground as in that position pressure on the knob(s) can damage the amplifier.
- Page 5 Step 2: Place the base on the seat as shown. The notch in the base should face the rear-most part (back end) of the seat. Make sure that each pair of bolts protrudes through the lateral slits of the base and the cable, which is attached to the amplifier, protrudes through the middle slit. Amplifier Notch Cable...
- Page 6 Step 4: Using the zip-tie fastener secure the amplifier cable to the power supply. This is used to maintain the connection. First secure the bottom zip-tie to the amplifier cable.
- Page 7 Step 5: Plug the power cable into the power supply and place the power supply on the floor at the location where the base will cover it when you place the SolTec Lounge in an upright position.
- Page 8 Then lift and place the SolTec Lounge on top of the power supply with the power cord exiting from the notch at the back end of the base as shown below. The power supply should be located underneath the base so that the cable slack can accommodate seat movement.
- Page 9 Once the SolTec Lounge is assembled plug the 3-prong power cable provided with the power supply (the small rectangular AC/DC converter) into a grounded wall outlet. Switch the on/off switch on the input faceplate on the side of the Lounge to on. The LED indicator for power on should be lit green.
- Page 10 (without headphones) in the room. If that sound is too high or low adjust the Lounge volume knob shown in the diagram above once you have the desired level of vibration.
- Page 11 Splitter output jack and the Lounge Input jack on the SolTec Lounge. Repeat this step for lounges 2 to 10 as needed. If you wish to link more than 10 lounges you can connect multiple splitters.
Need help?
Do you have a question about the Lounge and is the answer not in the manual?
Questions and answers