Subscribe to Our Youtube Channel
Related Manuals for Home Science Tools MI-4100STD
Summary of Contents for Home Science Tools MI-4100STD
- Page 1 Home Microscope Instruction Manual for MI-4100STD – Home Microscope MI-4100DXL – Home 1000x Microscope 1.800.860.6272 www.homesciencetools.com Copyright 2012 by Home Training Tools, Ltd. All rights reserved.
-
Page 2: Table Of Contents
To clean lens surfaces, remove dust with a These instructions are for two different soft brush or a can of compressed air. Then models with fluorescent lighting – MI-4100STD moisten a piece of lens paper (our item MI- and MI-4100DXL. Pages 2-4 will cover the basic... -
Page 3: Description Of Components
4x, 10x, and 40x, which multiply with the 10x eyepiece lens to adjusted with a lever. provide magnification levels of 40x, 100x, and 400x. The 4100DXL model also Condenser: MI-4100STD includes 100x objective 1000x condenser is fixed and the MI-4100DXL magnification. -
Page 4: Installing A Mechanical Stage
As indicated by the symbol, this model cord is out of the way so no one can trip is upgraded from the MI-4100STD. This section over it or pull it off of the table. describes each feature and how it is used. -
Page 5: Abbe Condenser
clockwise. Open the iris diaphragm by turning its lever clockwise. 1.25 Abbe Condenser Unlike the fixed condenser on the MI- 3. Place one drop of high quality immersion oil 4100STD model, this condenser (our item MI-IMMOIL) on top of the 4100DXL models is movable. -
Page 6: Adjusting The Stage Stop
pressure on the stage. This will allow you to scan a slide while maintaining fairly good Changing the Bulb focus. Your microscope bulb should last for years—approximately 8,000 hours. When it Filters burns out, follow these steps for replacing it: The MI-4100DXL model comes with a blue 1. -
Page 7: Troubleshooting
Troubleshooting If you experience difficulty with your microscope, try these troubleshooting techniques: Problem Possible Reason and Solution Light fails to The AC power cord is not connected. Connect the cord to an outlet. operate The bulb is burned out. Replace the bulb. (See “Changing the Bulb,” p. 6.) The power source outlet is inoperative. -
Page 8: Specifications
You will need to return your microscope freight prepaid for warranty service to Home Science Tools, or the repair facility we designate. We will repair or replace your microscope at no charge and return it freight prepaid to you.
Need help?
Do you have a question about the MI-4100STD and is the answer not in the manual?
Questions and answers