Summary of Contents for FlaktWoods FC102
-
Page 1: Table Of Contents
Frequency converter AIR COMFORT AIR COMFORT AIR TREATMENT FC102 (QUICK GUIDE) 9325 GB 2016.09.16 » INSTALLATION AND MAINTENANCE content page Safety instructions IT system 3x230VAC Connections Control unit (LCP) Manual operation Reverse the direction of rotation More information Wiring diagram... -
Page 2: Safety Instructions
For installation at height, contact Fläkt Woods it system (3x230vac) regarding PELV. When installing the FC102 on an isolated system (IT system, 3x230VAC) set parameter 14-50 to [0] Off. Press [Main Menu] twice. Navigate using take care! the [▲] [▼] and [OK] buttons until parameter... -
Page 3: Connections
Installation and maintenance Frequency converter Fc102 (quick guide) connections – principle image Control unit (LCP) RS 485 serial bus Analogue I/O LCP contact Analogue switches Cable support/ PE earth Earthing plate Earth clamp Shielded cable earth clamp and cable support... -
Page 4: Control Unit (Lcp)
Installation and maintenance Frequency converter Fc102 (quick guide) control unit (lcp) a. alphanumeric display The information displayed in the control unit display (LCP) can be customised. See parameters 0–20, 0–21, 0–22, 0–23 and Status 1(1) 0–24. The factory settings display: motor rpm, motor current, 1234rpm 1.0 A... -
Page 5: Wiring Diagram
Installation and maintenance Frequency converter Fc102 (quick guide) Wiring diagram Danfoss FC102 91 92 93 95 +24V +24V L1 L2 L3 PE DIG IN Start DIG IN DIG IN DIG IN DIG IN DIG IN DIG IN Analog switches +10V... -
Page 6: Basic Configuration
Installation and maintenance Frequency converter Fc102 (quick guide) Basic conFiguration For asynchronous machines (FlÄkt Woods standard) When the frequency converter is energized for the first time the language can be selected. Obviously this can be changed later. After Smart Start is started for 0...10VDC control by pressing [▼], followed by pressing [OK]. -
Page 7: Pid Regulation
Installation and maintenance Frequency converter Fc102 (quick guide) activating pid regulation step description Press [Quick menus] Press [Quick menus] Select Q3-3 Closed Loop Settings Select Q3-30 Single Zone Int.Setpoint 1-00 Confi guration Mode [3] Closed Loop [3] Closed Loop 20-12 Reference/Feedback Unit... - Page 8 Installation and maintenance Frequency converter Fc102 (quick guide) modBus rtu in eq If Modbus RTU is used in eQ AHU for controlling drives, they must be set according to the table below. configuration parameter description value 8-30 Protocol [2] Modbus RTU...