Advertisement
Specifications
Length – 24.25 in.
Width – 20. in.
Height – 48 in.
Weight – 85.5 Lbs.
Speed 175 Std, Two Speed 185/330
Pad Diameter 17 or 20 in. Drivers 16" & 19"
Drive motor – 1.5 HP, 120v, 12A, 60 Hz
1 HP, 120v, 12A, 60 Hz
-
Two Speed – 1.5 HP, 12 A, 60 Hz
Cord – 14-3 ST, 50 ft.
Hour meter – 0.1 hr resolution
Safety
Read and understand the manual
before operating this machine.
Do not operate in explosive areas or use near
flammable liquids or gases or dust.
Attach only to properly grounded outlet.
Do not expose to rain, store indoors.
Do not operate the machine with a damaged
cord or plug.
Do not block or disconnect the safety lever.
Do not leave the machine plugged in while
unattended.
Unplug the machine before servicing.
Do not put fingers under the pad or pad holder.
Unplug the machine before installing or
removing the pad.
Use only with Suitable Pads or Brushes.
NuSource, Ent. 8/27/2007
Operating Instructions
Check machine for damage to cord or plug.
Use suitable pads or brushes.
To install or change the pad:
1. Unplug the machine.
2. Tip the machine back on the wheels.
3. Install brush or pad driver.
4. Center the pad on the pad driver.
To operate the machine:
1. Plug into a grounded outlet.
2. Release the handle and lower it.
3. The handle should be locked into a
comfortable position for the operator.
4. Press the safety lever and squeeze the
trigger to start the machine.
5. Do not operate in one place as damage to
the floor or finish could result.
6. Do not operate the machine with the handle
in the upright position.
7. Remove the pad after every use.
8. Store the machine with the pad or brush
removed.
9. Use only new or clean pads and reverse
them as needed.
To maintain appearance – wipe the machine
with a damp cloth after use.
Warning – Unplug the machine before
servicing
This machine is equipped with an hour meter
to signal maintenance intervals of 250 hours. It
will begin flashing at 245 hrs and stop at 255
hrs to signal the operator to check the
following:
1. Check the motor brushes for wear or
excessive arcing on the two speed
machine.
2. Check the cord and electrical system.
3. Check the safety lockout on the trigger.
4. Check the wheels.
Page 3
Maintenance
Floor Machine
Advertisement
