Connections (Notifications); Antenna Connection; Other Connections - LG MT47 SERIES Owner's Manual

CAUTION
• Disconnect the power cord first, and then move or install the TV.
Otherwise electric shock may occur.
• If you install the TV on a ceiling or slanted wall, it may fall and
result in severe injury. Use an authorized LG wall mount and
contact the local dealer or qualified personnel.
• Do not over tighten the screws as this may cause damage to the TV
and void your warranty.
• Use the screws and wall mounts that meet the VESA standard. Any
damages or injuries by misuse or using an improper accessory are
not covered by the manufacturer's warranty.
• Screw length from outer surface of back cover should be under
8mm.
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
: M4 x L10
Max.8mm
NOTE
• Use the screws that are listed on the VESA standard screw
specifications.
• The wall mount kit includes an installation manual and necessary
parts.
• The wall mount bracket is not provided. You can obtain additional
accessories from your local dealer.
• The length of screws may differ depending on the wall mount.
Make sure to use the proper length.
• For more information, refer to the manual supplied with the wall
mount.

Connections (Notifications)

Connect various external devices to the TV and switch input modes
to select an external device. For more information about an external
device's connection, refer to the manual supplied with each device.
Available external devices are: HD receivers, DVD players, VCRs, audio
systems, USB storage devices, PC, camcorders or cameras, gaming
devices, and other external devices.
• The external device connection may differ from the model.
• Connect external devices to the TV regardless of the order of the
• If you record a TV programme on a DVD recorder or VCR, make
Back Cover
• Refer to the external equipment's manual for operating
• If you connect a gaming device to the TV, use the cable supplied
• In PC mode, there may be noise associated with the resolution,
• In PC mode, some resolution settings may not work properly

Antenna connection

Connect the TV to a wall antenna socket with an RF cable (75 Ω)
(Not Provided).
• Use a signal splitter to use more than 2 TVs.
• If the image quality is poor, install a signal amplifier properly to
• If the image quality is poor with an antenna connected, try to
• An antenna cable and converter are not supplied.

Other connections

Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
• USB port supports 0.5 A electric current. If you need more electric
NOTE
TV port.
sure to connect the TV signal input cable to the TV through a DVD
recorder or VCR. For more information of recording, refer to the
manual provided with the connected device.
instructions.
with the gaming device.
vertical pattern, contrast or brightness. If noise is present, change
the PC output to another resolution, change the refresh rate to
another rate or adjust the brightness and contrast on the PICTURE
menu until the picture is clear.
depending on the graphics card.
NOTE
improve the image quality.
realign the antenna in the correct direction.
current in case of HDD, use the separate power adaptor.
9