Advertisement
Operation of the Class Boosters -230, -330, -430
•
First select the right battery voltage (12V or 24V), then connect the battery terminals with the
battery poles.
•
Set the switch „2" to CB and the switch „4" to min-max, switch „3" and to „normal charging" or
to „2" „fast charging"
•
Turn on the booster by activating the switch „1" to „on" and the device starts charging!
•
If you want to start a car engine set switch „2" to „Start", then set switch „1" to „ON", wait for
two minutes, then try to start the engine for max. 4-5 seconds! If the engine does not start af-
ter 3-4 attempts, wait 10 minutes before repeating the operation, so that the battery continues
to charge and the loading device can cool down!
Operation of the Class Boosters -530, -630
•
First select the right battery voltage (12V or 24V), then connect the battery terminals with the
battery poles.
•
Set the switch „1" to „1", 2 or 3 means slow charging, while 4,5,6 means fast charging. Fast
charging takes mostly 1 hour and is normally controlled via timer.
•
If you want to start a car engine set switch „1" to „Start", wait two minutes and then try to start
the engine max. 4 up to 5 seconds long. If the engine does not start after 3-4 attempts, wait
10 minutes before repeating the operation, so that the battery continues to charge and the
loading device can cool down!
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 12
Advertisement
