Page 1
PS400 PISTOL PULL SETTER Wespro Power Tools Grease Fitting DO NOT clamp the handle in a vise or other clamping device ! Also DO NOT stamp the aluminum handle body anywhere with letter or number stamps. In doing so, the valve box can be fractured thus requiring a new handle.
Page 2
Western Office 604-298-2933 Eastern Office 905-428-1616 www.wespropowertools.com PS series Pull Setter operation manual Wespro Power Tools 1. Assemble the bearing set & draw bolt (part#2,3,4,5) as above shown figure. 2. Insert part#1 into Gun Body. Rotate part#1 until slot connects with Gun Body shown as figure.
Page 3
Practical Operations Insert the rivet nut into the prepared hole of work piece. Turn the rivet nut onto draw bolt first and insert rivet nut into work piece. Keeping the tool square to work piece. Press the top rocker trigger (pistol type) or lever (straight type). The tool will stall out when the rivet nut is completely installed.