Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Quality Products
for the way you live
INSTRUCTIONS FOR MODELS 4950/4955/4972
IMPORTANT: PLEASE KEEP FOR FUTURE REFERENCE!
For helpful tips and instructions, please visit our website: www.northstatesind.com or
Contact our Customer Care department via email: info@northstatesind.com
Phone: (763) 486-1756 or Toll Free: (800) 848-8421
Intended for use with children 6-24 months
Advertisement
Related Manuals for NORTH STATES 4950
Summary of Contents for NORTH STATES 4950
- Page 1 Quality Products for the way you live INSTRUCTIONS FOR MODELS 4950/4955/4972 IMPORTANT: PLEASE KEEP FOR FUTURE REFERENCE! For helpful tips and instructions, please visit our website: www.northstatesind.com or Contact our Customer Care department via email: info@northstatesind.com Phone: (763) 486-1756 or Toll Free: (800) 848-8421...
-
Page 2: Table Of Contents
This safety gate complies with ASTM F1004-10 Contents Page 2 Qty. Part Name 8-bar gate panel Upper panel assembly fitting Lower panel assembly fitting Upper latch Upper latch housing (w/gate stop) Lower latch Lower latch housing (w/gate stop) Hinge pin Hinge Hinge spindle with locknut &... -
Page 3: Upper Panel Assembly Fitting
Page 3 Installation and operation Measure the width of the opening where you intend to install the gate. Please refer to this measurement to determine the correct installation configuration. Preparation for Use Attaching the two gate panels 1. To begin setting the appropriate width of the gate, unscrew and remove the upper panel assembly fitting (P/N 2) and lower panel assembly fitting (P/N 3). -
Page 4: Upper Latch
Page 4 4. Repeat step 3 for the lower panel assembly fitting. Mounting the hinges 5. Hold template (A) against the surface to Hinge which the gate is to be fitted (hinge side). Ensure that the template is vertical, completely outstretched, and that the end marked “... -
Page 5: Lower Latch
Page 5 8. Remove the template and mount the upper latch (P/N 4) and upper latch housing (P/N 5) as shown in figure 8. Note that one side of the upper latch housing is Note higher than the other. This is the gate stop. raised edge The gate stop should be on the side to which... -
Page 6: Hinge
Page 6 Installing the gate 11. Place the upper and lower hinge spindles (see figures 11 and 12) on the upper and lower hinges as shown. Openings between 1.3” and 2.8” ( 33 mm- 72 mm) should exist between the outer gate bars and the mounting surface. -
Page 7: Wrench
Page 7 Verifying latch operation 15. Swing the gate closed. The only slight resistance you should feel is when the upper and lower latch spindles swing into the latches with the end of the spindles dropping automatically into the latch cups. (See figure 15). -
Page 8: Screw
3. Check regularly that all fittings are securely tightened and that the locking mechanism is working properly. Distributed exclusively in the United States by North States Industries, Inc. 1507 92nd Lane N.E. Blaine, MN 55449 www.northstatesind.com Manufactured in...