Advertisement
Selecting Heat or Cool
Set system switch to on.
Hold down
for 3 seconds to bring up the current mode.
Use
or
Wait 10 sec for the thermostat to return to
normal operation.
Tech Setup Steps
Heat or Cool
This feature allows the installer to
configure the thermostat for Heat only
or Cool only operation.
(reference the Selecting Heat or Cool
steps above for how to enter this Menu)
LCD Will Show
Adjustment Options
Heat or Cool
Factory Default Settings
Heat
PRO1 Tip
Temperature swing, sometimes called differetial or cycle rate, can be customized for this individual
application. For most applications choose a swing setting that is as long as possible without making
the occupants uncomfortable.
and
key
to select the mode.
Swing
The swing setting, often called "cycle rate",
"differential" or "anticipation" is adjustable.
A smaller swing setting will cause more
frequent cycles and a larger swing setting will
cause fewer cycles.
(reference the Technician Setup Menu
steps above for how to enter this Menu)
The swing setting is adjustable
from ±0.4°F to ±2°F. For example:
For example, a swing setting of 0.5 will turn
the system on and off at approximately 0.5º
away from the setpoint.
Only the swing for the selected mode
(Heat of Cool) is displayed in the Menu.
0.4 Heat and 0.5 Cool
Technician Setup Menu
This thermostat has a technician setup menu
for easy installer configuration. To set up the
thermostat for your particular application:
Set system switch to off.
1.
2.
Hold down
for 3 seconds.
3.
Configure the installer options as desired
using the table below.
4.
Use the
options below and the LIGHT key to move
from one step to another.
Temperature Setpoint Limit
This feature allows you to set a maximum heat
setpoint value. The setpoint temperature cannot
be raised above this value.
Use the
or
maximum heat setpoint or the minimium cool
depending on the selected mode (Heat of Cool).
25º for cool and 90º for heat
and
key together
or
keys to change the
key to select the
Advertisement
