Expert RF600 Instruction Manual

4-channel radio system

Advertisement

Quick Links

E X P E RT
4-Channel Radio System
I n s t ruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RF600 and is the answer not in the manual?

Questions and answers

Summary of Contents for Expert RF600

  • Page 1 E X P E RT 4-Channel Radio System I n s t ruction Manual...
  • Page 2 EXPERT Manual...
  • Page 3: Table Of Contents

    3.2 Receiver Layout......6 10.1 EXPERT Trainer System ....14 10.2 Operating the Trainer System .
  • Page 4: System Specifications

    • Servo reversing on all four channels (page 12) • 9.6V 600mAh transmitter Ni-Cad battery pack • Adjustable control stick length (page 6) • Power output approximately 500mw • Trainer system feature compatible with Expert and JR radio systems TRANSMITTER SPECIFICAT I O N S 4-Channel Analog System...
  • Page 5: Transmitter Layout

    Replace ** with channel number IMPORTANT Transmiter Battery Voltage LED Indicator Servo Reversing Switches Low Mid Full Red Orange Green Low: Do not fly Mid: System should be recharged Full: System ok to fly Carrying Bar 9.6V 600mAh Ni-Cad Transmitter Battery Pack EXPERT Manual...
  • Page 6: Control Stick Length Adjustment

    The eye hook is precisely positioned (see Section strap is used. 3. RF600 RECEIVER RECEIVER FEAT U R E S / S P E C I F I C AT I O N S • Patented noise rejection system for excellent interference •...
  • Page 7: Sl500 Servo

    2.24" x .59" x 2.05" Type Size (WxLxH) 1.2V x 4 Ni-Cad (4.8V 600mAh) Voltage Weight (oz.) 6. CHARGER SPECIFICAT I O N S 100-120V 15 Hours Input Voltage AC Charging Time Output Current 50mAh Transmitter/ 50mAh Receiver EXPERT Manual...
  • Page 8: Charging Your Expert Radio System Prior To Installation

    7. CHARGING YOUR EXPERT RADIO SYSTEM PRIOR TO INSTA L L AT I O N Your EXPERT Radio System is shipped from the factory with both the Under normal conditions, subsequent recharging of your EXPERT system transmitter and receiver NiCad batteries in a discharged state. Before...
  • Page 9: Pre-Installation System Preparation

    8. PRE-INSTA L L ATION SYSTEM PREPA R AT I O N FLIGHT PACK CONNECTIONS Connect all flight pack components of your EXPERT system as outlined in the diagram below: Receiver Battery 4.8V 600ma Not Used With 4-Channel System Not Used With...
  • Page 10: Transmitter Preparation

    Adjust each of the 4 trim levers (aileron, elevator, rudder, and throttle) to the center position. Gimble Gimble SYSTEM CHECK Slide the power on/off switch on your EXPERT Transmitter to the By moving each of the two transmitter sticks in a fore-aft, left-right “on” position. motion, the corresponding throttle, rudder, elevator, and aileron (optional) servo arm/wheel will rotate.
  • Page 11: Flight Pack Installation

    The flange of the brass eyelets should face down (toward the mount the switch in the most convenient place. Make sure the wood). See Section 9.3. switch operates freely and is capable of traveling its full distance. Servo Horn 90° with Servo at Control Rod Neutral/Center Position EXPERT Manual...
  • Page 12: Servo Reversing/Setting Reversing Switches

    Aileron Rudder Rudder Rudder Aileron Aileron Idle Up Elevator Idle Up Elevator Throttle Aileron Elevator Rudder Servo Reversing Switches High (Full) Rudder Aileron Down Aileron Up Carburetor Elevator Low (Idle) 1/16" Up Elevator Throttle Right Aileron Right Rudder EXPERT Manual...
  • Page 13: Adjusting Control Surface Travel

    The opposite holds true for the control surface arm (horn) as well. You may EXPERT Manual...
  • Page 14: Pre-Flight Information

    The EXPERT features a built-in trainer system. The transmitter can be radios that have built-in trainer systems. An optional trainer cord is used as either a master (trainer) or as a slave (trainee). The EXPERT is needed (EXRA400). compatible with all other current PPM selectable (FM) EXPERT or JR...
  • Page 15: General Notes

    6. Check to be sure that all servo pigtails and switch harness plugs 3. Ensure that all surfaces are moving in the proper manner. are secure in the receiver. Also, make sure that the switch harness moves completely in both directions. EXPERT Manual...
  • Page 16: Warranty And Service Information

    Within your letter, advise us of the payment method you prefer to use. Horizon Service Center accepts VISA or MasterCard, or we can return the equipment C.O.D. cash-only. If you prefer to use a credit card, include your card number and expiration date. EXPERT Manual...
  • Page 17: Frequency Chart

    72.990 REPLACEMENT CRY S TA L S Your EXPERT system has been designed to use the standard “JR” type FM crystals. As replacement crystal sets are not available through Expert, please use JR brand crystals for replacements (part number JRPXF**).
  • Page 18 EXPERT Manual...
  • Page 19 EXPERT Manual...
  • Page 20 Distributed exclusively by Horizon Hobby, Inc. Champaign, IL 61822 www.horizonhobby.com EXPERT Manual...

This manual is also suitable for:

Sl500

Table of Contents