Nintendo 64 Installation Manual page 5

Nintendo 64 Power Supply Capacitor Replacement Kit Installation Guide Page 5 of 9
Step One:
To start please turn over the power supply and locate the two 4.5mm security screws holding the casing
together seen in picture one below.
4.5mm Security Screws
Picture One: Back side of Nintendo 64 power supply
Once you have located them please unscrew the screws and remove the back casing. As you attempt to
remove the casings, the back casing snaps off relatively easily; however the top casing doesn't. It seems
as if it is still screwed in someplace; however this isn't true. There are two small foam sticky pads that
are glued to the top of the mother board and cement it to the inside of the top of the casing. If you pull
really hard you will be able to pull off the top casing. Once the casings have been removed then proceed
to step two.
V 1.0