Advertisement
M1-14207(2)
li3
1.
DISASSEMBLY
1-1.
REMOVAL OF CABINET, MECHANISM
UNIT AND MAIN BOARD
REMOVING
THE CABINET
PARTS (Fig. 1.1.1)
REMOVING
THE CP-1 PWB ASSEMBLY
(Fig. 1.1.3)
1.
Remove the cabinet and bottom cover by removing the
After removing
the cabinet
pa-
and the mechanism
four screws (A) and five screws (B).
unit
2.
Remove the front panel by removing the locks of the
1.
Pull outthe TM-1 PWBAss'yfrom
CN301 and CN302 while
clamps (C) using a screwdriver, etc. and slightly rotating
pressing and spreading out the four clamps (H) as shown
the bottom part in the direction of the arrow.
by the arrows.
NOTE:
Electrical adjustments
for the this model can be
2.
Remove the holder settothe opening of the chassis, while
performed with only the cabinet removed.
pressing the clamp in the direction of the arrow.
3.
Remove the two red screws (J). Next, remove the CP-I
REMOVING
THE MECHANISM
MAIN
UNIT (Fig. 1.1 .2)
PWB Ass'y by lifting it straight up while pressing and
After removing
the cabinet
pa-
spreading
out the two clamps
(K) as shown
by the
1.
Remove the two screws (D), and then remove the bracket.
arrows.
2.
Remove the 29-wire flat cable from the MC-2 PWB, and
then remove the 1l-wire flat cable from the VP-1 PWB
Ass' y.
3.
Remove the mechanism main unit by removing the two
screws (E) and two screws (F).
Remove, as well, the two screws (G) at the cassette tray
,
'$ ,. :,.> ,
.!.
side while pressing the tray lock lever as shown in the
enlarged view and pushing the cassette traytothe position
.
where the two screws (G) appear.
M-TEIUE-1
21
[1{....
Front Panel
'ALA
, Cabinet
-%'
I
$/"
(A)
v
'Main"nit
Bottom Cover
(B)
Fig. 1.1.1
_.
–2–
Hide quick links:
Advertisement
