Subaru IMPREZA 2002 Service Manual page 423

Hide thumbs Also See for IMPREZA 2002:

Table of Contents

1) Attach the stop light switch, etc. to pedal bracket

temporarily.

2) Clean the inside of bores of clutch pedal and

brake pedal, apply grease, and set bushings into

3) Align bores of pedal bracket, clutch pedal and

brake pedal, attach brake pedal return spring and

clutch pedal effort reducing spring (vehicle with hill

holder), and then install the pedal bolt.

Clean up inside of bushings and apply grease be-

fore installing the spacer.

Tightening torque:

T: 29 Nom (3.0 kgf-m, 21.7 ft-lb)

4) Set the brake pedal position by adjusting the po-

sition of stop light switch.

Pedal position: L

125.9 mm (4.96 in)

Tightening torque:

T: 8 N.m (0.8 kgf-m, 5.8 ft-lb)

E: INSPECTION

1) Move the brake and clutch pedal pads in the lat-

eral direction with a force of approximately 10 N (1

kgf, 2 Ib) to ensure pedal deflection is in specified

If excessive deflection is noted, replace the

bushings with new ones.

Deflection of brake and clutch pedal:

Service limit

5.0 mm (0.197 in) or less

(1) Clutch pedal

(2) Brake pedal

Chapters

Table of Contents