Table of Contents
Advertisement
(3) BNC IN: Connect a device that has composite video output with
BNC connector, such as a DVR or Camera.
(4) BNC OUT: Loop through of the BNC IN connector.
(5) AUDIO IN:Input the audio signal from the application to monitor
through audio cable under VGA or Video channel.
(6)AUDIO OUT:Audio signal loop through..
Connecting the Monitor
When choosing your workspace, select a sturdy, level surface. Also, make
sure you can easily access the back of the monitor. Easy access helps
ensure a smooth setup of the monitor.
Note: Before setting up your monitor, refer to the Important Safety
Information section at the beginning of this document.
1.Turn off your device.You should always turn off the device
Before connecting or disconnecting any device.
2. Connect one end of the VGA cable to the VGA connector on the monitor.
Connect the other end to your application's VGA connector
3. Connect one end of the audio cable to the monitor. Connect the other
end to an available port on your application.
4. Connect one end of the coaxial cable to the monitor BNC in connector .
Connect the other end to DVR or other equirpment.
5. IF you would like to connect your video source to another monitor or
device, you can use the BNC out connector
NOTE:the BNC out connector is auto terminated ,Do not connect a
cable to the BNC out unless it is connected to a terminated device
because it will cause poor quality video
6. Plug the AC/DC power supply into the monitor. Be sure to use the
original power adapter included with the monitor.
7. Connect the power cable to the adapter.
4
Note:the BNC out、S-video and VGA connectors can be connected to
one single monitors for simultaneous operation
Viewing the control panel
1.Buttons on the lower-right part of the panel
SOURCE
MENU
The buttons on the lower-right panel control your montor's basic
features,including the on-screen menu,to use the more advanced
features,you must use the remote control.
POWER press to turn the monitor on and off.
SOURCE: Accesses the available video input signals (VGA、AV、S-
VIDEO)
MENU： Brings up the MONITOR Main menu. When in the menu system,
displays sub-menus and selects highlighted items.
＋： Increases the volume. In the MONITOR menu system, acts like the
right arrow button ＞on the remote control and adjusts menu controls.
－ :Decreases the volume. In the MONITOR menu system, acts like
left arrow button＜ on the remote control and adjusts menu controls.
POWER INDICATOR
Blinks and turns off when the power is on and the lights up in stand-by
mode
REMOTER CONTROL sensor
Aim the remote control towards the spot on the monitor
+
-
POWER
the
5
Advertisement
Table of Contents
