Sealey VS912 Instructions

Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
Hot surfaces
instruction
manual
1. SafeTy
1.1. General safety
WArninG! ensure that Health & safety, local authority and general workshop practice regulations are adhered to when
‰
using this equipment.
familiarise yourself with the applications, limitations, and potential hazards of the thermal camera.
9
Keep the thermal camera clean and in good condition.
9
Protect the thermal camera from the following:
9
- thermal shock caused by large and/or rapid ambient temperature change.
9
- High temperatures.
do not get the thermal camera wet or use in damp or wet locations or areas where there is condensation.
8
do not use the thermal camera for any purpose other than that for which it is designed.
8
do not allow untrained persons (particularly children) to operate the thermal camera.
8
do not operate the thermal camera when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
WArninG! the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. it must be understood that common sense and caution are factors which cannot
be built into this product, but must be applied by the operator.
2. inTroducTion
combines the function of surface temperature measurement and real time thermal imaging. features a traditional image camera to pin point
test area with the ability to mix the thermal image over the top at varying intensities. includes on screen curser to accurately locate temperature
hotspots. suitable for many industries including automotive (Heated seats and windows, High resistance in high current wiring, overheating
wiring or components), building and electrical.
3. SpecificaTion
model no ..................................................................... Vs912
temperature range .............................. -20°C to 300°c(±2°C)
focal distance .............................. 50cm(min20cm, max 1mtr
field of Vision ...................................................................65°
screen size .................................................................. 52mm
resolution of infrared image ...................60x60 (3600 Pixels)
resolution of camera image .........................0.3 mega Pixels
colour Palette.......... iron red, rainbow, rainbow High contrast, Gray
emissivity ...............................................0.1 to 1.0 Adjustable
image mix (camera to thermal) ..0%, 30%, 60%, 80%, 100%
Power source ............................................... 4xAA (supplied)
Battery life ..................................................................6Hours
Weight ........................................................................... 320G
memory .......................... mini sd card (25,000 images max)
© Jack sealey limited
instructions for
Thermal imaging camera
VS912
model no:
Original Language Version
`
Vs912 | issue 1 20/05/16