Download Print this page

Step 8: Complete The Installation - Omega GPS-D4500 Installation Manual

Vehicle tracking & recovery system

Advertisement

Step 5: Apply power to the device
You can now plug the molex connector/wiring harness into the module
and insert the 3 amp fuse into the RED power wire. Also, be sure the ignition key
is in the ON/RUN position (this puts the device in full power mode to ensure con-
nectivity).
Step 6: Check the indicator lights
Locate the indicator lights on the end of the module. They are next to the
main connector. If everything is as desired, after a few minutes, you will notice
the YELLOW and ORANGE indicator lights will flash then eventually turn on
solid. Solid lights indicate proper connectivity and you can proceed to the installa-
tion test.
ORANGE light (cellular connectivity):
Off: No power, the cellular radio is OFF.
8
Blinking: The cellular radio is searching for service
8
Solid: Cellular service has been found with good signal strength
4
YELLOW light (GPS connectivity):
Off: No power or the ignition key is OFF, the GPS receiver is OFF.
8
Blinking: The GPS receiver is searching for satellite connectivity
8
Solid: GPS lock has been made with multiple satellites
4
Step 7: Test installation and activation
You Must Call 800-307-0680 Or The Owner Cannot
Use This Device!!
Be sure to have the activation card on hand with all the information de-
scribed in STEP 1. This phone call will only take a few minutes and is very impor-
tant to verify that the device is operating properly. Follow the prompts for testing
the installation and a live representative will walk you through the process.
ONCE THE TEST IS SUCCESSFUL, BE SURE TO HANG THE MIRROR
HANGER/ACTIVATION CARD ON THE MIRROR OR HAND IT DIRECTLY TO
THE END USER WHEN THE INSTALL IS COMPLETE. THEY WILL NEED
THIS INFORMATION TO ACTIVATE THE DEVICE FOR SERVICE.

Step 8: Complete the installation

After successfully completing the installation test, securely mount the
module in the selected location with tie straps, high grade hook & loop tape, or
any other reliable mounting method, and reassemble the vehicle's interior.
ONCE AGAIN, BE SURE THAT THE END USER IS GIVEN THE ACTIVATION CARD.
4

Advertisement

loading