Advertisement
OPERATION & MAINTENANCE
LED lights
Your cordless impact driver features a LED light system with
three LEDs (A) Fig.5 which gets activated by pressing the
trigger. This feature is ideal when working in partially lit work
environments.
Inserting/removing driver bit or nut driver into 1/4" quick
release chuck
Warning! Only use 1/4" driver bits or nut drivers with
identical dimensions as shown in Fig.6. Do not use any other
driver bits or nut drivers.
To install a driver bit or nut driver (C) Fig.7 into the 1/4" hex.
chuck (A), pull the chuck collar (B) Fig.7 away from the
impact driver and insert the bit into the chuck as far as it will
go. Release the collar to lock the driver bit into place.
Warning! If the driver bit is not fully inserted into the chuck,
the chuck collar will not return to the original position when
released and the driver bit will not lock into place.
To remove the driver bit, pull the chuck collar away from the
impact driver and pull the driver bit out.
Impact action
When this impact driver reaches a certain torque, the impact
function is engaged and a clicking sound will be heard, this
is normal.
MAINTENANCE
WARNING: NO USER SERVICE-AbLE PARTS INSIDE
Preventative maintance performed by an unauthorized
personnel may result in the misplacement of internal wires
and componenets which could cause serious hazards. We
recommend that all servicing be performed by a qualified
KING CANADA service centre technician.
battery
Pay attention to the battery power levels as the battery nears
its end of life. If you notice a decrease in battery performance or a significant difference in
running power between charges, then it is time to replace the battery. Failure to do so may
damage the charger and cause improper operation.
Tool lubrication
This tool has been properly lubricated and will never require additionnal lubrication.
Cleaning
To avoid accidents, always remove the battery from the cordless impact before cleaning. The
tool is most effectively cleaned with the use of an air compressor. Always wear safety glasses
when using an air compressor. Ventilation openings and switch levers must be kept clean and
free of foreign objects. Do not insert pointed objects through these openings in the attempt to
clean them.
1. Air vents of the tool should be cleaned regularly to avoid overheating of the motor which is
caused by the blocking of the air vents.
2. DON'T clean this tool with water, as no liquid is allowed in the tool body. Clean the tool with
a dry clean cloth only. Compressed air at low pressure is also suitable.
3. DON'T allow petroleum based products to come into contact with the plastic parts of the tool,
as they contain chemicals that can damage or destroy the plastic parts.
Figure 5
Figure 6
Figure 7
Advertisement
