Audiovox NAV101 Owner's Manual And Installation
Sub-woofer speaker system with dual satellite tweeters
Hide thumbs
Also See for NAV101:
- Datasheet (5 pages) ,
- Update manual (98 pages) ,
- Installation and operation manual (37 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Audiovox NAV101
Summary of Contents for Audiovox NAV101
- Page 1 O O O O O WNER'S MANU WNER'S MANU WNER'S MANU AL WNER'S MANU WNER'S MANU INST INST INST INST INST ALLA MODEL SU-101 SUB-WOOFER SPEAKER SYSTEM DUAL SATELLITE TWEETERS ALLA ALLA TION GUIDE TION GUIDE ALLA TION GUIDE ALLA TION GUIDE TION GUIDE WITH...
-
Page 2: Table Of Contents
6:30AM - 5PM 7:30AM - 6PM 7AM - 3PM 8AM - 4PM Page 2 Satellite Tweeter Configuration Wiring Instructions Page 3 SU-101 Speaker System Page 3 Interconnection Wiring Diagram Page 3 Use of Controls Page 4 Troubleshooting Page 5 Specifications... -
Page 3: Packing List
Bracket Tweeter Mtg Retaining Hex-Head Tapping Screw Plate (with Captive Washer) 5mm x 25 mm Tweeters (2) SAFETY TWEETER LANYARD SPEAKER BRACKET MTG SCREWS TWEETER SWIVEL BRACKET 1 pc 1 pc 1 pc 2 pcs 1 pc 2 pcs 4 pcs... -
Page 4: Placing The System
4. NEVER try to extend the length of the cables supplied with your system. The High Level Input/Output cable from the speaker enclosure and the four RCA jacked extension cables are 15 feet long. DO NOT exceed this length in your installation. -
Page 5: Installation Sub-Woofer
INSTALLATION SUB-WOOFER ENCLOSURE The SU-101 sub-woofer enclosure is designed for horizontal (flat) mounting. It must never be mounted upside-down or on either of it's sides. The most convenient area for enclosure installation is within the trunk of cars, such as sedans, or on the rear cargo area of vans and SUVs. -
Page 6: Satellite Tweeter Configuration
If the speaker is not assembled as shown, assemble the swivel bracket and lanyard to the speaker as illustrated. The bracket, lanyard and screws are packed with each speaker. -
Page 7: Wiring Instructions
4. Speaker Connections Wire the satellite speakers to the "Speaker Output" terminals as per the Output Wiring Diagram using the supplied input/output extension cable assemblies. When mating the wiring to the speakers, pay careful attention to the polarity of the speaker leads, and make certain they correspond to the polarity of the corresponding terminals on the highlevel input/output 10-pin adapter harness. -
Page 8: Su-101 Speaker System
SU-101 SPEAKER SYSTEM INTERCONNECTION WIRING DIAGRAM ( + ) RIGHT REAR LEFT REAR SPEAKER LEFT REAR RIGHT FRONT TO FRONT SPEAKERS (WHEN USED) LEFT FRONT EXISTING SCREW OR BOLT CLEAN PAINT, RUST, DIRT OR GREASE FROM AREA FOR GOOD CONNECTION... -
Page 9: Use Of Controls
RCA connector (LINE OUT) from the vehicle radio receiver. 6 6 6 6 6 HIGH LEVEL INPUT/OUTPUT CONNECTOR This 10-pin connector provides audio (speaker) connec- tions between the sub-woofer enclosure, the satellite tweet- ers and existing audio receiver system. 7 7 7 7 7... -
Page 10: Troubleshooting
Consult with service facility. 8" Cone Type 3" Satellite Speaker 4 Ohms Low-Level RCA Jack and High Level Speaker Inputs 360 Watts 55 Watts (150 Hz, 0.1% THD) 0.2 - 4.0 V Low Level 0.4 - 8.0 V High Level <... -
Page 11: Warranty
90 DAY LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.