JVC LT-26WX84 Service Manual page 16

3.1.10 REMOVING THE LCD PANEL UNIT
NOTE:
The LCD PANEL is fixed to the FRONT PANEL (at the back
side) by using double-side adhesive tapes. To remove the
LCD PANEL, remove the adhesive tape on the FRONT PAN-
EL slowly.
• Remove the STAND.
• Remove the REAR COVER.
• Remove the POWER CORD.
• Remove the RECEIVER.
• Remove the FRONT CONTROL PWB.
• Remove the FRONT SENSOR PWB.
• Remove the VIDEO PWB.
• Remove the DIGITAL INPUT MODULE PWB.
• Remove the MI-COM & DIST MODULE PWB.
• Remove the POWER PWB.
(1) Remove the 8 screws [d] and the 2 screws [e] (ten screws
in total). Then, remove the LCD PANEL UNIT.
(2) Remove the 2 screws [f], and remove the CENTER
FRAME (x2).
(3) Remove the 2 screws [g] and the 2 screws [h] (4 screws in
total). Then, remove the FRAME (R).
(4) Remove the 2 screws [g] and the 2 screws [h] (4 screws in
total). Then, remove the FRAME (L).
(5) Remove the 2 screws [j], and remove the TOP FRAME.
(6) Remove the 3 screws [k] and the 2 screws [m] (5 screws in
total). Then, remove the BOTTM FRAME.
1-16 (No.YA089)
a
LCD PANEL
e
d
Adhesive tape
Fig.3-1-10A
CENTER FRAME
f
X
P
Q
Fig.3-1-10B
g
FRAME(R)
TOP FRAME
h
j
Fig.3-1-10c
d
e
d
Adhesive tape
f
FRAME(L)
h
g
BOTTOM FRAME
h
m