Siemens KI42F SERIES Instructions For Use Manual page 16

en
Fault
Appliance has no
refrigeration capacity.
The light does not work.
The display does not
illuminate.
Appliance is not cooling,
temperature display and light
are lit.
The light does not function.
The "cool-fresh"
compartment is too warm or
too cold.
16
Possible cause
Appliance has been switched
off.
Power failure.
The fuse has been switched
off.
The mains plug has not been
inserted properly.
Showroom mode is
switched on.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
The standard setting has
been set too high or too low
(e.g. if there is frost
in the "cool-fresh"
compartment).
Remedial action
Press the On/Off button.
Check whether the power is on.
Check the fuse.
Check whether the mains plug is secure.
Hold down alarm button, Fig "/1, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
The temperature in the "cool-fresh"
compartment can be set to be 2 steps warmer
and/or colder, Fig. ". If the refrigerator
compartment temperature is set to 4,
the "cool-fresh" compartment has
a temperature of almost 0 °C.
1. Press super button on refrigerator
compartment 2 for 3 seconds until a signal
sounds.
Temperature display on refrigerator
compartment 4 flickers.
2. Change the setting using the temperature
setting button on refrigerator
compartment 3.
Setting 2 – coldest setting
Setting 8 – warmest setting
The set temperature is saved after one
minute.