Ambilight Menu; Ambilight; Brightness; Mode - Philips 32PFL7332D/37 User Manual

Ambilight menu

CAUTION: Infrared interference
To avoid bad infrared remote control
reception, place your peripheral equipment
out of sight of the ambient lights of your TV.
Ambilight does not function well when the
room temperature is less than 59°F/15°C.
Enjoy Ambilight
The ambilight menu contains the settings for controlling the ambient lighting. Ambi-
ent light gives a more relaxed viewing experience and improves perceived picture
quality. Analysis of the picture content adapts the colors continuously. But the lights
can also be set to any fi xed color and many shades of white.
& Press the MENU button on the remote control.
é Use the cursor down to select TV settings in the TV menu.
" Use the cursor right to enter the TV settings menu.
'
Select Ambilight and press the cursor right.

Ambilight

Off: To switch off the ambient lights and downlight all other menu items.
On: To switch on the ambient lights. Refi ne the light settings in the menus below.

Brightness

To adjust the light output of the ambient lights.

Mode

Color:

To show constant light according to the settings in the Ambilight
color menu. See below.
Relaxed: To change the rate of brightness and color change is smoothly
and soft which gives you a more immersive yet relaxed viewing.
Moderate: To change the rate of brightness and color change as pre
defi ned in the factory.
Dynamic: To infl uence the dynamic impression.
Notes: - The rate of change is limited, as not to cause uncomfortable sensations.
- According to the selection made, some Ambilight menu items will be
down lighted and can not be selected.
Color
Select Color and press the cursor right.
Warm white: The color is matched to that of most normal lightbulbs. Select
this setting if you want the Ambilight to fi t best with normal
living room lighting.
Cool white: The color is matched to that of normal daylight (6500K). Select
this setting if you prefer more cool lighting.
Note: The 6500 K is the SMPTE recommended setting for ambient
backlighting of displays.
Blue: The blue color is preferred by most consumers to create a cool,
modern and/or mystical atmosphere. Select this setting according
to your personal taste or mood.
Red: Preferred by most consumers to create a cosy, special atmo
sphere. Select according to your personal taste or mood.
Custom: Select this if you want to customise the ambilight colour.
Custom Color (only available when Custom has been selected in the Colour menu.)
Allows you to customise the ambilight colour.
Palette: to adjust the general colour of the light output.
Saturation: to adjust the colourfulness of the light.

Separation

Allows you to defi ne the stereo effect when one of the following options is
selected on the Mode menu: Relaxed, Moderate or Dynamic.
Select Off for a mono behavior which means that all lamps will behave equally.
Select Minimum, Medium or Maximum to defi ne the Ambilight stereo effect
spread over the available lamps.

Color Boost

Allows you to adjust the color level of light intensity.

Balance

Allows you to adjust the color level of light intensity on the sides of the picture.
13