FGM TC 155 GTI Operator's Manual page 7

PLACING THE GRASS COLLECTOR
ON THE TRACTOR (Fig. 6).
Fig. 6
Proceed to the following steps:
1. Lift the grass collector assembly with
both hands. Slant it to an angle of
approximately 40 degrees (Fig. 6).
2. Slide the grass catcher on the two
support brackets located on the rear collector
plate of the tractor. Check out the alignment
of grass collector cover to the fender. In case
it is not fitting precisely adjust the position
of grass collector using the movement
of the braces on the slots or by light bending
of the braces.
3. When the grass catcher is properly
positioned, place the decal with the
triangle symbol directly opposite to the
symbol on the rear of the tractor. This
will assist alignment in the future (Fig. 7).
ASSEMBLY
This tractor is equipped with a safety
micro-switch and the cutting system will
not function when the grass collector
assembly is not in place. Do not tamper
PREPARATION BEFORE THE FIRST OPERATION
The tractor is shipped without gas
for safety reasons.Check oil level.
Fill fuel tank with reccommended gas.
Lead acid batteries generate explosive
gases. Keep sparks, flame and smoking
materials away from batteries. Always wear
eye protection when around batteries.
6
Fig. 7
WARNING
with this microswitch.
DANGER