To Supply Power Source - Panasonic SL-DV100 Service Manual

5 To Supply Power Source

Caution:
· It is very dangerous to look at or touch the laser
beam.(Laser radiation is invisible.)
With the unit turned on, laser radiation is emitted from
the pickup lens.
· Avoid exposure to the laser beam, especially when
performing adjustments.
This unit SL-DV100 is designed to operate on power
supplied form the system
connection, refer to Fig.1.
Notes:
Use only this method when checking the voltage etc..
In case of checking operations, use the system
connections to supply power source.
connected. For system
Fig.3.
When the unit SL-DV100 has to test and service alone, use
the following method to supply power source.
1. Short the JK1-3 pin, JK1-6 pin, JK1-10 and JK1-17.
Refer to Fig.2.
2. Connect a DC power supply to JK1-5 pin and
adjust the output to 10 V. Refer to Fig.3.
Fig.2.
5
Fig.1.
. Then
SL-DV100