Advertisement
English
1 Important
Congratulations on your purchase and welcome to Philips! To fully benefit
from the support that Philips offers, register your product at
www.philips.com/welcome.
Read this user manual carefully before you use the appliance, and save the
user manual for future reference.
Danger
Do not immerse the motor unit in water nor
•
rinse it under the tap.
Warning
Never use your fingers or an object to push
•
ingredients into the feeding tube while the
appliance is running. Only use the pusher.
Before you connect the appliance to
•
the power, make sure that the voltage
indicated on the bottom of the appliance
corresponds to the local power voltage.
Never connect this appliance to a timer
•
switch, to avoid a hazardous situation.
Do not use the appliance if the power cord,
•
the plug, protecting cover, rotating sieve or
any other parts are damaged or has visible
cracks.
If the power cord is damaged, you must
•
have it replaced by Philips, a service center
authorized by Philips, or similarly qualified
persons to avoid a hazard.
This appliance shall not be used by
•
children. Keep the appliance and its cord
out of reach of children.
This appliance can be used by persons
•
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use
of the appliance in a safe way and if they
understand the hazards involved.
For their safety, do not allow children to
•
play with the appliance.
Never let the appliance run unattended.
•
If food sticks to the wall of the blender jar or
•
bowl, switch off the appliance and unplug
it. Then use a spatula to remove the food
from the wall.
Be careful when you are emptying the
•
bowl, handle or clean the discs, the blade
units and the juicer sieve. The cutting
edges are very sharp.
Do not touch the blades, especially when
•
the appliance is plugged in. The blades are
very sharp.
If the blades get stuck, unplug the
•
appliance before you remove the
ingredients that block the blades.
Be careful if hot liquid is poured into the
•
food processor or blender as it can be
ejected out of the appliance due to a
sudden steaming.
This appliance is intended for household
•
use only.
Caution
Never switch off the appliance by turning
•
the blender jar, the bowl, or their lids.
Always switch off the appliance by turning
the speed selector to 0 or OFF.
Unplug the appliance immediately after
•
use.
Always wait until the moving parts stop
•
running, then switch off and unplug the
appliance before opening the lid and
reaching into any of the parts that move in
use.
Always switch off and unplug the appliance
•
if it is left unattended, and before
assembling, disassembling, cleaning and
changing accessories, or approaching parts
that move in use.
Thoroughly clean the parts that come
•
into contact with food before you use the
appliance for the first time. Refer to the
instructions and table for cleaning given in
this manual.
Never use any accessories or parts from
•
other manufacturers that Philips does
not specifically recommend. If you use
such accessories or parts, your guarantee
becomes invalid.
Do not exceed the maximum level
•
indication on the bowl or the jar. Follow the
quantities, processing time and speed as
indicated in the user manual.
Let hot ingredients cool down (< 80ºC)
•
before processing them.
Always let the appliance cool down to
•
room temperature after each batch that you
process.
Certain ingredients such as carrots may
•
cause discolorations on the surface of the
parts. This does not have a negative effect
on the parts. The discolorations usually
disappear after some time.
Noise level: Lc = 78 dB [A]
•
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic fields (EMF). If handled properly and
according to the instructions in this user manual, the appliance is safe to use
based on scientific evidence available today.
Recycling
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
When you see the crossed-out wheel bin symbol attached to a
product, it means the product is covered by the European Directive
2002/96/EC:
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of
electrical and electronic products. The correct disposal of your old
product helps prevent potentially negative consequences on the
environment and human health.
2 Before first use
Before you use the appliance and accessories for the first time, thoroughly
clean the parts that come into contact with food.
To explore more helpful tips and basic recipes online, you can:
1
Go to www.philips.com.
2
Click the search button
on the homepage.
3
Type the product number "HR7759" in the search box.
4
Find or download the information you need from the searching result.
3 Food processor
General Assembly
Before you use or assemble any of the accessories, make sure that you
assemble according to Fig. 10 to 15.
1
Align the indicator on the bowl edge to the unlocking symbol on the
motor unit and attach the bowl to the motor unit.
2
Turn the bowl clockwise until you hear a click to fix it onto the motor unit.
3
Assemble the accessory or the accessory equipped with the shaft to the
bowl.
4
Put the ingredients in the bowl.
5
Put the lid on the bowl, and turn the lid clockwise until you hear a click to
fix it. Then put the pusher into the feeding tube.
•
For the discs, put the ingredients into the feeding tube with the
pusher.
6
Connect the power plug to the power supply.
7
Check the advised ingredient quantity and setting in Table 1. Turn the
knob to the desired speed setting.
8
After use, turn the knob to 0, and then unplug the appliance.
Blade unit
Before you start, make sure that you assemble according to Fig. 10.
You can use the blade unit to chop, mix, or puree ingredients.
To remove the food that sticks to the blade or bowl wall, stop processing and
switch off the appliance first, and then use a spatula.
Note
•
Always put the blade unit in the bowl before you start to add the ingredients.
•
Do not use the blade unit to chop hard ingredients, like coffee beans, turmeric,
nutmeg, and ice cubes, as this may cause the blade to get blunt.
•
Do not let the appliance run too long when you chop (hard) cheese or chocolate.
Otherwise these ingredients become too hot, start to melt, and turn lumpy.
Kneading accessory
Before you start, make sure that you assemble according to Fig. 11.
You can use the kneading accessory to knead yeast dough for bread and
pizzas. You need to adjust the amount of liquid to form the dough according
to the humidity and temperature condition.
Discs and Inserts
Before you start, make sure that you pick your desired disc from following and
assemble according to Fig. 12 and Fig. 13.
Disc/
Name
Purpose
Insert
To prepare food like whipped cream
Emulsifying disc
through whipping or whisking
Insert for fine slicing
To cut ingredients into thin flat pieces
Insert for coarse
To cut ingredients into thick flat pieces
slicing
Insert for fine
To cut or tear cheese or raw vegetables
shredding
into fine thread
Insert for coarse
To cut or tear cheese or raw vegetables
into thicker thread
shredding
To form or crystallize ingredients into
Insert for granulating
grains or granules
Disc for slicing /
To cut ingredients into thin flat pieces /
shredding (fine):
fine threads
Disc for slicing /
To cut ingredients into thick flat pieces /
thicker threads
shredding (coarse):
Disc for French fry
To cut ingredients into thicker strips
To form or crystallize ingredients into
Disc for granulating
grains or granules
Disc for julienne
To cut ingredients into fine strips
To assemble the disc inserts, follow the steps below:
1
Place the opening of the insert over the shaft of the insert holder.
2
Push the opening of the insert over the projection on the shaft.
3
Press the insert onto the insert holder until it locks in position with a click.
Caution
•
Be careful when you handle the slicing blade of disc. It has a very sharp cutting
edge.
•
Never use the disc to process hard ingredients, like ice cubes.
•
Do not exert too much pressure on the pusher when you press ingredients into the
feed tube.
Note
•
Put the ingredients into the feeding tube with the pusher. Fill the feeding tube
evenly for the best results. When you have to process a large amount of ingredients,
process small batches and empty the bowl between batches.
Mini chopper
Before you start, make sure you assemble according to Fig. 14.
You can use the mini chopper to chop coffee beans, peppercorns, nuts, herbs,
dried fruits etc.
Note
•
You can order a mini chopper jar and a blade unit (under service code number 9965
100 57198/9965 100 52997) from your Philips dealer or a Philips service center as
extra accessories.
•
Follow the recommendation on Table 1. Do not exceed the maximum level indicated
on the mini chopper.
Tip
•
For best results when processing beef, please use refrigerated beef cubes. Use max
of 100g beef cubes at speed P for 5 sec.
•
How to remove the ingredients that stick to the side of the mini chopper? 1. Switch
off the appliance, and then unplug it. 2. Remove the beaker from the blade unit. 3.
Remove the ingredients from the blade or from the side of the beaker with a spoon.
4 Blender
Before you start, make sure you assemble according to Fig. 15.
The blender is intended for:
•
Blending fluids, like dairy products, sauces, fruit juices, soups, mixed
drinks, and shakes,
•
Mixing soft ingredients, like pancake batter,
•
Pureeing cooked ingredients, like baby food.
Note
•
Never open the lid to put your hand or any object in the jar while the blender is
running.
•
Always assemble the sealing ring onto the blade unit before you attach the blade
unit to the blender jar.
•
To add liquid ingredients during processing, pour them into the blender jar through
the feeding hole.
•
Precut ingredients into small pieces before you process them.
•
If you want to prepare a large quantity, process small batches of ingredients instead
of a large quantity at once.
•
To avoid spillage: When you process a liquid tends to foam (for example, milk), do
not put more than 1 liter of liquid in the blender jar.
•
Put the ingredients in the blender jar within the maximum level indication.
5 Cleaning and storage
Caution
•
Make sure that the cutting edges of the blades and discs do not come into contact
with hard objects. This may cause the blade to get blunt.
•
The cutting edges are sharp. Be careful when you clean the blade unit of the food
processor, the blade unit of the blender and the discs.
1
Clean the motor unit with a moist cloth.
2
Clean the other parts in hot water (< 60ºC) with some washing-up liquid
or in a dishwasher.
3
Store the product in a dry place.
6 Guarantee and service
If you have a problem, need service, or need information, see
www.philips.com/support or contact the Philips Consumer Care Center in your
country. The phone number is in the worldwide guarantee leaflet. If there is no
Consumer Care Center in your country, go to your local Philips dealer.
2/2
Advertisement
