Advertisement
4. Dismantling
1.
Loosen screws (20, 21), remove handle cover
(19).
2. Clqmp off cable from switch (12), clamp off capacitor (17)
at
motor housing (1).
3. Clamp off carbon cable, pull carbon brush (5) out of
holder.
4. Loosen screws (50, 51), remove and dismantle outer bearing
(37)
with intermediate bearing (36). Draw out drill shaft (39).
5. Pull armature out of motor housing.
6. Pull air conducting ring (10) out of motor housing, loosen
screws
(9), take out pole housing (7).
Re-assemble in reverse sequence.
S.
Stationary use
in·
the bench drill stand
If the machine is constantly used in the bench drill stand remove drill
after 50 working hours and turn by 180° just after operation to
lubricate the
pinion.
After 150 working hours check the lubrication of
the pinion. Loosen
screws
(50, 51) and take off gear
head.
6. Repair and Spare Parts
We recommend our Fein Service Stations to carry out all overhaul
and repair work quickly and expertly.
Please quote Order Reference when ordering spare parts or
send in sample part, stating the type of the machine.
We draw your
attention
to the need to carry out a high
voltage
test
in accordance with
your
local regulations
(or
VDE regulation 0740)
before taking a tool into service after any repair carried out by
your
own
staff.
I
(
Advertisement
