locksonline CL4000 Programming & Operating Instructions Manual

CL4000 Programming & Operating Instructions
CODES
•
The factory set Master Code is #1234. This should be changed immediately after installation (see program 10).
•
The Master Code and optional Sub-Master Code always start with the # prefix. This puts the lock into Programming
Mode.
•
When the Master or Sub-Master Code is entered 3 times consecutively without performing a programming function, a
penalty time of 10 seconds is activated. This feature is to discourage the casual use of Master Codes as User Codes.
•
The length of the Master Code determines the length of the User Code and the Sub-Master Code.
•
If the Master Codes is changed to another of the same length then the Sub-Master and all User Codes will be retained.
•
If the Master Code is change to one of a different length then the Sub-Master and User Codes will be deleted.
•
Codes may be 4, 5 or 6 digits long.
•
The lock memory will store 80 different User Codes, each identified by a User Code ID – 01 to 80.
•
The lock memory can store 10 different One Time User Codes. Each One Time User Code is identified by a One Time
User Code ID – 81 to 90.
•
When in Programming Mode a Program Code must be entered within 5 seconds, otherwise the Red light will flash and
beep and the lock will revert to normal.
•
If a programming mistake is made wait 5 seconds, the Red light will flash and beep and the lock will revert to normal.
•
A new code will be rejected if it is already in the memory.
OPERATING INSTRUCTIONS
The CL4000 locks have an 11 button keypad including the Badge Bar which acts as the # button.
UNLOCK TIME
The factory pre-set UNLOCK time is 4 seconds. This may be changed – (see Program 06).
PENALTY TIME
Entering 3 incorrect User codes will cause the lock to suspend activity for a penalty time of 10 seconds.
KEY OVER-RIDE
The Key-in-Lever allows the lock to be opened for Security and Housekeeping Functions. Turn the key clockwise 90°
and operate the lever handle to open the door.
CODE FREE MODE
Using the Master or the Sub-Master Code, programs 08 and 09 will put the lock into, and out of, Code Free Mode. In
Code Free Mode battery power is not being used.
If the Master and Sub-Master Codes cannot be issued for this purpose it is possible to use the Key-in-Lever to put the
lock into Code Free Mode. This requires that the cylinder tailpiece be changed according to the instruction. (SEE
LATER)
REVERTING TO FACTORY SETTING
If the Master Code is not known the lock memory can be cleared and made to revert to the factory Master Code as
follows:
1. Remove one battery.
2. Press and hold the '0' button, replace the battery, the Blue LED will flash twice, beep will sound twice, then release
the '0' button.
3. Within 3 seconds press the '0' button 3 times. The Blue LED will light continuously for 7 seconds and then 2 beeps
will sound. The lock will have reverted to the factory set Master Code, #1234, and all other settings will be erased.
REMOTE RELEASE OPTION
The lock has 2 sets of terminals for remote release, labelled REM 1 and REM 2 on the printed circuit board in the front
housing. Cables are provided with the lock for these connections