Safety Precautions; Handling Cautions - Canon EF-S55-250mm f/4-5.6 IS Instruction

L't-
Safety Precautions
• Do not look at the su n or a bright light source
through the lens or camera. Doing so could
result in loss of vision. Looking at the su n directly
through the lens is especially hazardous.
• Whether it is attached to the camera or not, do
not leave the lens under the su n without the
lens cap attached. This is to prevent the lens !rom
concentrating the sun's rays, which could cause a
fire.
Handling Cautions
• lf the lens is taken from a cold environment into
a warm one, condensation may develop on the
lens surface and internai parts. T o prevent
condensation in this case, firsl pul the lens into an
airtighl plastic bag before taking il !rom a cold to
warm environment. Then take out the lens alter it
has warmed gradually. Do the same when taking
lhe lens !rom a warm environmenl into a cold one.
• Do not leave the lens in excessive heat such as in
a car in direcl sunlight. High temperatures can
cause the lens lo malfunction.
ENG-2
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. lf such changes or
modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits fora class B digitai device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. lf this equipment does cause harmful
interference to radio or television reception , which can be
determined by turning the equipment off and on, the user is
encouraged to try to corree! the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• lncrease the separation between the equipment and receiver.
• Consult the dealer or an experienced radiofTV technician far
help.
This Class B digitai apparatus complies with Canadian ICES-003.
Nomenclature
Hood mount
(~5)
~--------
Filter mounting
thread (~ 8)
Focusing ring (~ 4)
Focus mode switch (~ 4)
!]"V'.(
'i§>'">A<:::-'. Zoom position index
Lens mount index (~ 4)
lmage stabilizer switch
(~6)
Contacts
(~
4)
For detailed information, reference page numbers are provided in parentheses
(~ **).
ENG-3